Indoor Humidity Sensor
Product Information Sheet
203-5753
Installation
The connections of the indoor humidity sensor to the
input point on the 16AI board are polarity sensitive.
The sensor is connected as shown in the Sensor
Wiring Diagram. The sensor can be wired to any
available point on the 16AI board. Connect the wires
as indicated:
1. Connect PWR to +12VDC on 16AI
2. Connect OUT to SIG on 16AI
3. Connect COM to 0V on 16AI
This sensor (pictured above) is manufactured by Greystone Energy Systems
Inc. and is a registered trademark of that company.
The dip switch for the 16AI input should be set to the
OFF position.
The sensor does not include any mounting hardware.
The sensor can be secured directly to a single
electrical box or to a wall using appropriate wall
anchors.
Sensor Wiring Diagram
EmersonTM, Emerson. Consider It SolvedTM and Emerson Climate TechnologiesTM logos are trademarks and service marks of Emerson Electric Co
Intelligent StoreTM is a trademark of Emerson Climate Technologies. All other trademarks are the property of their respective owners.
© 2011 Emerson Climate Technologies, Inc. All rights reserved.
Greystone is a registered trademark of Greystone Energy Systems, Inc.
32