‫بسـم اهلل الرحمن الرحيم‬
‫جامعة بوليتكنك فلسـطين‬
‫كلية الهندسة والتكنولوجيا‬-‫دائرة الهندسة الكهربائية‬
Power Electronics
Submission deadline: 2 weeks
Project#1 /Ch.3
‫ أهندسة تكنلوجيا الطاقة‬،‫ هندسة أتمة صناعية‬:‫التخصص‬
‫ الفصل السادس‬: ‫المستوى‬
-----------------------------------------------------------------------------------------------------
1. Design and build a single-phase uncontrolled rectifier circuit of ;
Full-wave with 5A dc current, 42 V dc voltage , the current ripples must be
within 5%, and the voltage ripples must be within 10%.
-
Determine the tr-r parameters
Determine and select the diodes ratings
Calculate the necessary protections
Calculate the L and C filters that satisfied the above mentioned conditions.
Build the simulation model by selecting two of these Software programs (
Simulink, PSPICE, PSIM, PSCADE,….). Plot the waveforms….
- Build (practically implement) the designed circuit.
===========================================================
2. Design and build a three-phase uncontrolled rectifier circuit of ;
Full-wave with 4A dc current, 100 V dc voltage , the current ripples
must be within 0.05%
-
Determine the tr-r parameters
Determine and select the diodes
Calculate the necessary protections
Calculate the voltage reduction due to L .
Build the simulation model by selecting two of these Software programs (
Simulink, PSPICE or PSIM).Plot the waveforms….
- Practically Implement the electrical circuit with necessary protections (without
tr-r part). The build model should be energized by laboratory transformer with
rating no more than 1KVA.
Instructions:
1.The project must computer typed.
2.The implemented circuits must satisfy the safety regulations and instructions
3.Use appropriate software ( PSPICE, PSIM, SIMPLORER, Matlab/Simulink, PSCADE,)…..
4. This task must be team worked with maximum 2 students in the team…
5.Any suggestions and new ideas are appreciated.
6.Submission date : April,01/2013
Dr. Sameer Khader
Date: 14.03.2013