Fixture Type APPROVAL Lamp Type Job Ref. / Location SERIES N4X, 12N4X STANDARD FEATURES q Dual Voltage Input - 120/277 VAC 60 Hz. q Factory cycle tested for reliability. q Shipped fully assembled, ready to install. q Suitable for NEMA 4, 4X & 12 – Watertight & Corrosion Resistant. q Rugged Grey Structural Thermoplastic Housing. Optional white epoxy finish. q Corrosion Resistant Stainless Steel Hardware. q Removable Hinged Access Door is Fully Gasketed to Insure Proper Seal. q Watertight Integrity of Lighting Heads is Assured with the use of Construction Grade RTV Silicone Sealant. q Mounting Provisions Provided. q Breather Vent. 6 Volt - 12 Volt NEMA 4X Emergency Lighting CHARGER/BATTERY q Solid state, patented POWER PULSE* charger. q Sealed lead acid maintenance free battery – 8 year life expectancy. q Low battery voltage disconnect, brownout, power-on latch. q Temperature compensation. q Controls: Red LED power on. q Push to test switch. q D.C. load fusing. * Patent No. 4890004 SVS SELF VERIFIED SYSTEM SELECTION GUIDE Available with 6 V O L T 12 V O L T MODEL NUMBER PAR-36 SEALED BEAM PAR-36 SEALED BEAM LAMP LIGHTING FIXTURES LIGHTING FIXTURES WATTAGE* D.C. HALOGEN TUNGSTEN HALOGEN/TUNGSTEN VOLTS TOTAL D.C. WATTAGE FOR SUSTAINED ILLUMINATION 1.5 2 4 HOURS HOURS HOURS N4X12-2LH N4X18-2LH N4X24-2LH — N4X18-2L N4X24-2L 6 / 0 8 / 9 8 / 9 6 6 6 12 18 24 8 12 16 5 7 10 12N4X24-2LH 12N4X36-2LH 12N4X50-2LH 12N4X100-2LH 12N4X180-2LH 12N4X24-2L 12N4X36-2L 12N4X50-2L 12N4X100-2L 12N4X180-2L 8 / 8 8 / 8 8 / 12 8 / 12 8 / 12 12 12 12 12 12 24 36 50 100 180 16 24 40 84 144 10 14 22 44 72 *NOTE: Lamp type and/or wattage may be substituted to suit specific application requirements. (Contact factory). APPLICATIONS NOMINAL DIMENSIONS 111/2" 3 133/4" (171 /2") 45/8" 8"(12") MountingCenter Dimensionsin (parenthesis)arefor 12N4X180-2LH or 12N4X180-2L only 4MountingHoles 5/ "Diameter 16 123/4" (163 /4") MountingCenter 13/4" (123 /4") (151/2") TECHNICAL DATA 12 Volt Wire Runs for Remote Loads* 53/8" (63 /8") OPTIONS Item Ideal for use in hostile environments where dirt, dust, oil, water or corrosive elements such as salt, acids, alkalines, etc. are present. Best suited in areas such as petro-chemical plants, waste water treatment or processing plants. Although it may be used outdoors, exposure to direct sunlight or high ambient temperatures should be avoided. Add Suffix/Prefix Self Verified System...................................................#–SVS Low Ambient Temperature Control......# – TC1 (120V), # – TC2 (277V) Nickel Cadmium Battery............................................#– NI 3 Ft. Cord Set..........................................................#– CP3 Time Delay for use with HID.......................................#– TD Lamp Disconnect......................................................#– LD Tamperproof Screws.................................................#– TP Side Mount Heads....................................................#– S 220V 50 H2 input....................................................#– 220V50 White Epoxy Finish....................................................W–# Total Allowable Wiring Distance Watts............. #12 Wire.............. #10 Wire 12.....................178'....................... 283' 25......................85'........................ 135' 50......................42'......................... 67' 100.....................21'......................... 33' *6 volt – Multiply Distance by .24 INPUT...........120/277 VAC....... 60Hz – 24 Watts All products are manufactured in accordance with U.L. standard 924, and meet or exceed requirements as established by the National Electrical Code Article 700 and Life Safety Code NFPA101. Specifications subject to change without notice. IU1.0 CDUECR Pathway Lighting Products, Inc., P.O. Box 591, Old Saybrook, CT 06475-0591 voice: 800.342.0592 • fax: 800.207.0090 • www.pathwaylighting.com • e-mail: sales@pathwaylighting.com