TOP VIEW
SIDE VIEW
1 1/8"
ISOMETRIC VIEW
STEP 2
STEP 1
1 1/2"
4 7/16"
4 7/16"
6"
11 7/8"
PIPE COPED AT ONE END
FOR 1 1/2" TUBING
1 9/16"
4 7/16"
1 1/8"
2.197
1 1/2"
1/4" HEX NUT
WELDED DIRECTLY OVER HOLE
(3) PLACES
2.197
FRONT VIEW
STEP 3
R9/16"
PART 1
1 15/16"
R5/16"
R1/2"
Project Description:
11/16"
THREADED
PART 2
SKU/MATERIAL
QTY.
SUPPLIED BY ESAPCO
PART 1 (2.197")
PART 2 (2.197")
1
1
YES
YES
EYE BOLT (1/4")
3
NO
HEX NUT
3
NO
PART SKU / TEMPLATE:
1/4"
Drawn:
COUPLER, TEE 1.90
Name:
JJR
Date:
1/10/2008
107630
Revisions:
---
---
---
---
---
---
Finish shall be either: Galvanized, Electroplate, or Min. 2mm Aluminum Paint
Gauge:
16
GALV
Material:
Comments: Do Not Scale.
PDMWorks Project:
Vault Project Here
Job Number:
---
THIS DOCUMENT CONTAINS INFORMATION PROPRIETARY TO CLEARSPAN FABRIC STRUCTURES
INTERNATIONAL, INC. IT SHALL NOT BE REPRODUCED, USED, OR DISCLOSED WITHOUT
PRIOR WRITTEN PERMISSION OF CLEARSPAN FABRIC STRUCTURES INTERNATIONAL, INC.
Tolerances (In Inches, Unless Otherwise Specified): FRACTIONAL 1/32 | ANGULAR .5 | ONE PLACE DECIMAL
TWO PLACE DECIMAL
.03 | THREE PLACE DECIMAL .01
.06 |
To develop the full strength at pipe joint, the all around fillet welds shall be sized as follows:
Thickness of Material:
14 GA
13 &12 GA
11 &10 GA
9 &8 GA
7 GA
Min. Weld Size:
1/8"
5/32"
3/16"
7/32"
1/4"
Note: When tubes of different wall thickness are jointed, the min. fillet weld size shall be based on the thinner member.
Sheet #: 1 of 1