Ground Stakes for
Palladian Trellis
NOTE: BEFORE ASSEMBLY, MAKE SURE YOU HAVE
ALL PARTS LISTED BELOW.
Parts:
A. Stakes - set of 2
Tools Required for Assembly
You will need a rubber mallet if you plan to anchor the trellis in the soil.
A. Stakes
Parts:
A. Stakes - set of 2
Mounting your trellis as free standing
In areas with soft soil, the Stakes (A) may be used.To install the trellis slide the
Stakes (A) into the vertical square tubes located on both sides of the trellis.
Make sure that trellis stands straight and levelled.
Drive Stakes (A) into the ground with a rubber mallet (the trellis may not
stand upright without support in very soft soil). In areas with moderate-tohard ground you may need to dig small holes to receive the stakes.
For additional support, wall mounts may be used (not included).
Caring for your Trellis and Stakes
This powder–coated steel garden structure is resistant to the effects of sun,
rain, frost and snow. It may be left outdoors year-around.To clean, simply wipe
with a damp cloth. If the powder-coat finish should chip or scratch, it may be
touched up with rust-proof enamel (not included).