330L/330M POCKET DOOR LATCH INSTRUCTIONS
1.
2.
3.
1 7/8"
2 5/16"
B
A
CUT NOTCH IN THE DOOR AT
THE DESIRED HEIGHT.
4.
SLIDE THE LATCH INTO PLACE SO THAT THE
FRONT FACE OF THE LATCH IS FLUSH WITH
THE DOOR EDGE.
STRIKE OUTLINE
5.
6.
CL
LA
TC
C
L H
FR
A. TIGHTEN MACHINE SCREWS TO
AUTOMATICALLY ALIGN THE PULL
ON THE DOOR.
B. INSTALL (2) #6 x 5/8" OPHWS TO THE
DOOR.
CL
2 1/4"
C
L
AM
E
1"
15/16" HOLE
1/2" DEEP
C
L
DO
OR
DRILL 15/16" DIAMETER HOLE
1/2" DEEP IN CENTER OF THE
MORTISE
SCREW STRIKE PLATE INTO
POSITION USING (2) #6 x 3/4"
FPHWS.
MARK LATCH CENTERLINE ON FRAME SO THE
LATCH AND STRIKE LINE UP. USING THE
CENTERLINES AS A GUIDE, MARK AROUND THE
STRIKE. MORTISE THE STRIKE OUTLINE WITH A
CHISEL 3/64" DEEP.
SW
AP
WHEN IT IS DESIRABLE TO REVERSE THE
PLATES ON THE LOCK ASSEMBLY, FOLLOW
THESE STEPS:
1. REMOVE MACHINE SCREW ON EACH SIDE,
2. SWAP POSITIONS OF THE TWO PLATES.
3. MAKING SURE THE TWO FORKS ARE
ENGAGED ON THE ROCKER PINS,
REASSEMBLE THE PLATES USING THE
SCREWS FROM STEP 1.
B
BEFORE
AFTER
DETAIL B
BOTH FORKS MUST BE IN
PLACE BEFORE TIGHTENING
PLATES TOGETHER.
DRAWING NO: I-TA00739
REV: 01
SHEET 1 OF 1
HAGER COMPANIES 139 Victor Street, St. Louis, MO 63104 - (800) 325-9995 - Fax (800) 782-0149