Page 1 of 1
REV-02
Fastenal Product Standard
Date: March 9, 2016
TROD.B7.Z
Threaded Rod, ASTM A193 B7, Zinc Plated
The information below lists the required dimensional, chemical and physical characteristics of the products in this purchase order. If
the order received does not meet these requirements, it may result in a supplier corrective action request, which could jeopardize your
status as an approved vendor. Unless otherwise specified, all referenced consensus standards must be adhered to in their entirety.
Diameter
Nominal
Size
1/4-20
5/16-18
3/8-16
7/16-14
1/2-13
9/16-12
5/8-11
3/4-10
7/8-9
1-8
1 1/8-8 *
1 1/4-8 *
1 3/8-8 *
1 1/2-8 *
.2500
.3125
.3750
.4375
.5000
.5625
.6250
.7500
.8750
1.000
1.125
1.250
1.375
1.500
D (Major Diameter)
Max.
.2489
.3113
.3737
.4361
.4985
.5609
.6233
.7482
.8731
.9980
1.1229
1.2479
1.3728
1.4978
Min.
.2367
.2982
.3595
.4206
.4822
.5437
.6051
.7288
.8523
.9755
1.1079
1.2329
1.3578
1.4828
Length
Tolerance
3'
+/- 1/4"
6' - 12'
+/- 1/2"
Length shall be measured form end to end
Specification Requirements:
•
•
•
Dimensions:
Material &
Mechanical Properties:
Thread Requirements:
Finish:
Product Marking:
•
Material Test Reports:
•
•
ASME B18.31.3
ASTM A193/A193M, B7
Roll threaded to ASME B1.1 UNC, UNF, & 8UN Class 2A
Fe/Zn 3AN per ASTM F1941/F1941M
Marked with predetermined color code on rod end.
Vendor to supply color code with the MTR and purchase order.
The MTR must have documented lot traceability, dimensional
results, full chemical test results and full mechanical test results
to the specification(s) above. In addition, the MTR shall be in full
compliance with Fastenal’s MTR Requirements.