BRAVO Inverter, 2500VA Inverter (-48Vdc + 230Vac) /

advertisement
BRAVO Inverter, 2500VA
Inverter
(-48Vdc + 230Vac) /
230Vac
Features and Benefits

Dual input sources (AC & DC)

Compact and lightweight solution

High efficiency

Full scalability and expandability

Hot swappable

Pure sine wave on AC output

Transfer time reduced to naught

No single point of failure

Total modularity as no external
static-switch required
DC Power for
Business-Critical Continuity ™
Description
Inverter systems are normally used for AC backup requirements in a
telecom / datacom site or anywhere a highly reliable AC power back up
source is needed.
BRAVO is a compact and scalable inverter providing a pure sine wave AC
supply. In conjunction with a DC Power system, it provides an excellent
AC backup solution. The TSI (Twin Sine Inverter) uses the latest inverter
technology, providing superior energy efficiency in a compact size.
The inverter is designed to work from 230Vac and 48Vdc sources through
AC/AC and DC/AC conversions. Unlike traditional inverters, the TSI features
an AC to AC conversion that assures double filtering function. This results in
an efficiency of 96% without any compromise in quality and stability of the
output wave form. This off line operation mode is called “Enhanced Power
Conversion” (EPC).
The EPC mode, which is the filtering of current and voltage, is similar to a
rectifier combined with an inverter (online mode) but gives a significantly
better efficiency. Compared to a UPS operating in offline mode (no current
conversions) the efficiency is the same, but the rejection of grid disturbances
is much higher.
The online mode is usually only used during a mains outage when inverters
are fed by batteries. Therefore, the TSI inverters will almost constantly
provide an efficiency of 96%. It will always be the most reliable AC backup
solution!
The TSI inverters also have an in-built static switch function. Because no external
static switch is needed, the inverter system becomes smaller, more reliable and
easily expandable. As many as 32 inverter modules can be used in parallel.
BRAVO Inverter, 2500VA
Inverter Power Flow Diagram
Standard Feature – Offline Mode
AC in
➡
Backup Feature – Online Mode
➡
AC
AC in
AC out
AC
DC in
➡
AC
AC out
DC in
DC
➡
Output power comes from AC in
Inverter is fed from AC commercial grid
AC
DC
➡
➡
Output power comes from DC in
Inverter is fed from the DC Power system
Technical Specifications, TSI BRAVO
General
EMC (immunity)
EMC (emission)
Safety
Cooling
Isolation
MTBF
Efficiency (Typical)
EN 61000-4
EN 55022 (Class B)
IEC 60950
Forced
Doubled
240,000 hrs
Enhanced power conversion 96%
On line 91%
DC/AC 4300Vdc
Compliant
3 disconnection levels on AC out and DC in
Power ports
4 disconnection levels on AC in port
Dielectric Strength
True Redundant Systems
RoHS
Connection
Compliant
I/O terminal block protected against inversion
of polarity
Self adaptive to wide operating conditions and
comprehensive table of troubleshooting codes
Trouble-free Operation
AC Output Power
Nominal Output Power
Output Power (resistive load)
Short Time Overload Capacity
Permanent Overload Capacity
Admissible Load Power Factor
Internal Temperature Mgmt.
2500 VA
2000 W
150% 5 second
110%
Full (power rating from 0 inductive to 0 capacitive)
Switch off
DC Input Specifications
Nominal Voltage (DC)
Voltage Range (DC)
Current (at 40Vdc)
Maximum Input Current
Recommended Protection
Voltage Ripple
Input Voltage Boundaries
48 V
40 - 60 V
56A (224A per shelf)
84A (336A per shelf for 5 seconds)
63A circuit breaker per inverter
2mV
User selectable
AC Input Specifications
Nominal Voltage (AC)
Voltage Range (AC)
Current (at 185Vac)
Conformity Range
Power Factor
Frequency Range (selectable)
Synchronization Range
AC Output Specifications
Nominal Voltage (AC)*
Voltage Range (AC)
Voltage Accuracy
Frequency
Frequency Accuracy
Total Harmonic Distortion (resistive load)
Load Impact Recovery Time
Turn On Delay
Nominal Current
Crest Factor at Nominal Power
(with short circuit mgmt. and protection)
Short Circuit Clear up Capacity**
230 V
200 - 240 V
2%
50 - 60 Hz
0.03 %
<1.5 %
0.4 ms
20 s
10.9 A (protected against reverse current)
3.5
10 x In for 20msec
* Operation within lower voltage networks leads to derating of power.
** Available while Mains is available at AC input port,
with magnitude control and management.
Transfer Performance
Maximum Voltage Interruption
Total Transient Voltage Duration (max)
0s
0s
Environment
Altitude Above Sea
Ambient Temperature
Storage Temperature
Relative Humidity
<1500m
-20 to 50 °C
-40 to 70 °C
95% , non-condensing
Signaling & Supervision
Display
Alarms Output
Supervision
Synoptic LED
Dry contacts on shelf
Use optional devices
Weight & Dimensions
Width x Depth x Height
Weight
Material (casing)
102 x 435mm x 2U
5 Kg
Coated steel
230 V
185 - 265 V
56A per shelf
Adjustable
>99%
50 - 60 Hz
47 - 53 Hz, 57 - 63 Hz
Emerson Network Power.
The global leader in enabling
Business-Critical Continuity™.
www.emersonnetworkpower.com
www.emersonnetworkpower.com/energysystems
www.DCpowerefficiency.com
• AC Power
• Connectivity
• Infrastructure Management & Monitoring
Embedded Power
• Precision Cooling
• Racks & Integrated Cabinets
• DC Power
• Outside Plant
• Services
• Embedded Computing
• Power Switching & Controls
• Surge Protection
Business-Critical Continuity, Emerson Network Power
and the Emerson Network Power logo are trademarks
and service marks of Emerson Electric Co.
©2010 Emerson Electric Co.
Emerson Network Power reserves the right to alter without notice the specification, design or conditions of supply of any product or service.
EN/LZT 145 299 RA
Download