QUICK SPEC
STRUCTURAL CONCRETE - Elastuff® 101 with Elastuff® 103
NOTE: The following “Quick Spec” is an abbreviated specification and is not meant to replace the detailed specification. Read
the entire 3-Part CSI System Specification prior to starting the project.
Method

Spray, roller, or brush
Requirements




Moisture survey recommended.
Roof must be clean, dry, and tight.
Adhesion test required to ensure proper adhesion to substrate(s).
Apply at 50°F (10°C) and rising with no rain or freezing temperatures in forecast for 24 hours.
Application
Instructions
1.
2.
Conduct moisture survey and remove/replace all wet areas.
Repair or replace damaged or deteriorated sections with like materials, allowing cementitious
products to cure properly.
Repair membrane including seams, penetrations, flashings, curbs, and terminations with like
materials.
Power-wash roof. It is recommended to use United Cleaning Concentrate (UCC) to clean the
roof. Allow the roof to completely dry.
Treat all roof penetrations, drains, curbs, and scuppers.
Treat any loose seams.
Apply coating per the chart below:
3.
4.
5.
6.
7.
Elastuff® 101/103 - STRUCTURAL CONCRETE & STRUCTURAL
TRANSITE
Warranty
Elastuff® 101
Elastuff® 103 Top Coat
Total System
Base Coat DFT 1st Coat DFT 2nd Coat DFT
TTL
DFT
Limited Emerald Diamond
(Gal/Sq) (mils)* (Gal/Sq) (mils)* (Gal/Sq) (mils)* (Gal/Sq) (mils)* Warranty Pledge Pledge
10 Year
1.50
19.25
1.50
13.95
15 Year
1.50
19.25
1.25
11.63
1.00
9.30
3.00
33
Yes
Yes
No
3.75
40
Yes
Yes
No
* Dry Film Thickness (DFT) does not include Primer; uses the average % solids by volume and is rounded to nearest mil, and is theoretical.
Actual DFT will vary dependent on substrate profile, application technique & waste factors.