EC312 Homework 27 Name: ____ ______________ 1. Given the following ARP table, make the necessary change(s) to cause all Ethernet traffic destined for 192.168.14.10 to flow to you (192.168.14.13) instead? IP 192.168.14.8 192.168.14.9 192.168.14.10 192.168.14.12 192.168.14.13 192.168.14.21 192.168.14.25 MAC AA:BB:CC:DD:EE:FF AA:BB:AA:BB:AA:BB CC:DD:CC:DD:CC:DD EE:FF: EE:FF:EE:FF A4:B5:C6:D7:E8:F9 C6:D7:C6:D7:C6:D7 E8:F9: E8:F9:E8:F9 2. Why is the destination hardware address all 0s in the ARP request message? 3. Why would the destination hardware address of the frame be a broadcast address? 4. When initially establishing contact with the Dynamic Host Control Protocol (DHCP) to acquire an IP address, a host will transmit an IP packet saying “Give me an address.” If you examined the header of the IP packet, what would be the source IP address and the destination IP address? 5 . Combine the following three blocks of addresses into a single block ( Show your work using binary bits) : • 16.27.24.0/26 • 16.27.24.64/26 16.27.24.128/25 sk matching sk matching 6. Can router R1 in figure below receive a packet with destination address 140.24.7.194? What will happen to the packet if this occurs? sk matching Figure 22.8 Longest mask matching 7. Assume router R2 above has fixed its routing table below and it ngest matching ngest mask mask matching address 140.24.7.42. How is the packet routed to its final destination? 22.18 receives a packet with destination 8. Construct the routing table for router RB in the picture shown below. Network address/mask Next-hop address Interface