Chapter 7 Spectroscopy is the study of the interaction between radiation (electromagnetic radiation, or light, as well as particle radiation) and matter. Spectrometry is the measurement of these interactions and an instrument which performs such measurements is a spectrometer or spectrograph. A plot of the interaction is referred to as a spectrum. The spectrum of colors emitted by atoms that have been heated to high temperatures is called an atomic emission spectrum. Light is electromagnetic radiation, a wave of electric and magnetic field that travels at the speed of light(3.00х108m/s). Light waves travel at a constant speed. Because of this there is a one to one relationship between light's wavelength and its frequency. If waves are short, there must be more of them in a set amount of time to travel the same distance in that time (the same speed). The unit of frequency is Hertz(Hz) 1Hz=1cycle/sec The intensity of the light is proportional to the square of the amplitude of the wave. The distance between adjacent peaks gives its wavelength,λ. λ=c/ν Our eyes detect electromagnetic radiation with wavelengths from 700nm(red light) to 400nm(violet light). The electromagnetic radiation in this range is called as visible light. Ultraviolet radiation(UV) has a frequency higher than that of violet light; its wavelength is less than about 400nm. Infrared radiation(IR) has a frequency lower than that of red light ;its wavelength is greater than about 800nm. Microwaves, used in radars and microwave ovens, have wavelengths in the millimeter to centimeter range. What is the wave length of orange light of frequency 4.8х1014Hz? Electromagnetic radiation is a stream of many packets of electromagnetic energy. These packets are called as photons. The photon is the elementary particle responsible for electromagnetic phenomena. The photon travels (in vacuum) at the speed of light, c. Energy is transferred in discrete amounts called as quantum(plural quanta) Like all quanta, the photon has both wave and particle properties (“wave particle duality “). The more intense the light the greater the number of photons passing a given point each second. The relation between the energy , E of a photon and the frequency ν, of the radiation as E=hν where h is Plank’s constant, with a value of 6.63х10-34 J.s What is the energy in kilojoules per mole of photons of amber light of frequency 5.2х1014 Hz? A student’s favorite radio station broadcasts a signal at a frequency of 91.5MHz. What is the energy of the photon’s broadcast? Page 314 7.12,7.14 and 7.18 The Lyman series is the wavelengths in the ultraviolet (UV) spectrum of the hydrogen atom, resulting from electrons dropping from higher energy levels into the n = 1 orbit. The Balmer series is the wavelengths in the visible light spectrum of the hydrogen atom, resulting from electrons falling from higher energy levels into the n = 2 orbit. The Paschen series is the wavelengths in the infrared spectrum of the hydrogen atom, resulting from electrons falling from higher energy levels into the n = 3 orbit. Rydberg formula for hydrogen Where λvac is the wavelength of the light emitted in vacuum, RH is the Rydberg constant for hydrogen. The Bohr model of the hydrogen atom where negatively charged electrons confined to atomic shells encircle a small positively charged atomic nucleus, and that an electron jump between orbits must be accompanied by an emitted or absorbed amount of electromagnetic energy hν. The orbits that the electrons travel in are shown as grey circles; their radius increases n2, where n is the principal quantum number. The 3→2 transition depicted here produces the first line of the Balmer series, and for hydrogen (Z = 1) results in a photon of wavelength 656 nm (red). Louis-Victor formulated the de Broglie hypothesis, claiming that all matter, not just light, has a wave-like nature; he related wavelength (denoted as λ ), and momentum (denoted as p): This is a generalization of Einstein's equation above, since the momentum of a photon is given by p=E/c and the wavelength by λ=c/f, where c is the speed of light in vacuum. Calculate the wavelength of a marble of mass 5.00 g traveling at 1.00m/s. Our current model of a hydrogen atom was proposed by the Austrian scientist Erwin Schrodinger. He devised an equation (Schrodinger’s Equation)that enabled him to calculate the shape of the wave associated with any particle. Quantum theory is based on Schrodinger's equation; Hψ=Eψ in which electrons are considered as wave-like particles whose "waviness" is mathematically represented by a set of wave functions ψ, obtained by solving Schrodinger's equation. The wave function for an electron is so important that it is given a special name an atomic orbital. Atomic orbitals have characterestic energy and shapes. The different shapes are identified by different letters. An s orbital is a spherical cloud that becomes less dense as the distance from the nucleus increases. p-orbital is a cloud with two lobes on opposite sides of the nucleus. The lobes are separated by a nodal plane. The d and f orbital have complicated shapes. As for p-orbital the opposite shades of color denote opposite signs of wave. The location of an electron is best described as a cloud of probable locations. Page 314 7.30,7.34,7.36 Each orbital has a characteristic energy. When Schrodinger solved his equation, he found that the allowed energies of the electron in a hydrogen atom are given by the expression E=-hRH /n² n=1,2… RH, is called as the Rydberg’s constant. The experimental value of Rydberg’s constant=3.29х1015 Hz Whenever the atom emits a photon of radiation, the energy emitted is equal to the difference in two of the allowed energy levels. Each transition corresponds to a line in the spectrum of atomic hydrogen. Calculate the wavelength of a photon emitted by a hydrogen atom when an electron makes a transition from an orbital with n=3 to one with n=2. Schrodinger found that each atomic orbital is identified by three numbers called quantum numbers. The quantum number n is called the principal quantum number. The orbital angular momentum quantum number, l, specifies the shape of the orbital. The magnetic quantum number,ml specifies the individual orbital of a particular shape. An orbital is specified by three quantum numbers; orbitals are organized into shells and subshells. An electron has the property of spin ; the spin is described by the quantum number ms which may have one of the two values. Calculate the total number of orbitals in a shell with n=6. In a many-electron atom, because of the effects of penetration and shielding, s-electrons have a lower energy than p-electrons of the same shell; the order of increasing orbital energies within a given shell is s<p<d<f. No more than two electrons may occupy any given orbital. When two electrons do occupy one orbital, their spins must be paired. If more than one orbital in a subshell is available, electrons will fill empty orbitals before pairing in one of them. The ground state electron configuration of an atom of an element with atomic number Z is predicted by adding Z electrons to available orbitals so as to obtain the lowest total energy. Predict the ground state electron configuration of a sulfur atom and draw the box diagram. Predict the ground state electron configuration of a magnesium atom. To predict the electron configuration of a cation , remove outermost electrons in the order np, ns,and(n-1)d For an anion, add electrons until the next noble gas configuration has been reached. Page 315 7.42,7.44,7.48, Atomic radius: The atomic radius is defined as half the distance between the centers of neighboring atoms. Atomic radii generally increase down a group and decrease from left to right. The ionic radius of an element is its share of the distance between neighboring ions in an ionic solid. Ionic radii generally increase down a group and decrease from left to right across a period. Cations are smaller than their parent atoms and anions are larger. Arrange each pair of ions in order of increasing ionic radius:(a)Mg2+ and Ca2+ (b)O2- and F The ionization energy of an element is the energy needed to remove an electron from an atom of the element in the gas phase. For the first ionization energy we start with a neutral atom. For the first ionization energy,I1, we start with the neutral atom, for example, for copper, Cu(g)Cu+(g) +e-(g) I1 =(energy of Cu+ +e-)-(energy of Cu) The experimental value for copper is 785kJ/mol.The second ionization energy I2 is the energy required to remove an electron from a singly charged gas phase cation. For copper Cu+(g) Cu2+(g) + e-(g) I2=(energy of Cu2+ +e-)-(energy of Cu+)For copper I2 =1958kJ/mol The second ionization energy is always greater than the first because once the first electron is pulled off, you are now trying to remove the second electron from a positively charge ion. Because of the electrostatic attraction between + and -, it is more difficult to pull an electron away from a positively charge ion than a neutral atom. The first ionization energy is highest for elements close to helium and is lowest for elements close to cesium. Second ionization energies are higher than first ionization energies (of the same element). An ionization energy is very high if the electron is to be expelled from a closed shell. The electron affinity is a measure of the energy change when an electron is added to a neutral atom to form a negative ion. For example, when a neutral chlorine atom in the gaseous form picks up an electron to form a Cl- ion, it releases an energy of 349 kJ/mol or 3.6 eV/atom. An electron affinity of -349 kJ/mol and this large number indicates that it forms a stable negative ion. Small numbers indicate that a less stable negative ion is formed. Groups VIA and VIIA in the periodic table have the largest electron affinities. Elements with the highest electron affinities are those close to oxygen, fluorine, and chlorine. Group 17 atoms can acquire one electron with a release of energy and group 16 atoms can accept two electrons with chemically attainable energies. The halogens typically form X- ions and group 16 elements form X2- ions. On moving diagonally across the periodic table, the elements show certain similarities in their properties which are quite prominent in some cases as shown below. This is called a diagonal relationship. A Diagonal Relationship is said to exist between certain pairs of diagonally adjacent elements in the second and third periods of the periodic table. These pairs (Li & Mg, Be & Al, B & Si etc.) exhibit similar properties; for example, Boron and Silicon are both semiconductors form halides that are hydrolysed in water and have acidic oxides. Such a relationship occurs because crossing and descending the periodic table have opposing effects. On crossing a period of the periodic table, the size of the atoms decreases, and on descending a group the size of the atoms increases. Similarly, on moving along the period the elements become progressively more covalent, less reducing and more electronegative whereas on descending the group the elements become more ionic, more basic and less electronegative. Thus, on both descending a group and crossing by one element the changes cancel each other out, and elements with similar properties which have similar chemistry are often found - the atomic size, electronegativity, properties of compounds (and so forth) of the diagonal members are similar. Page 315 7.62,7.64, Page 316 7.70,7.78,7.80,7.90