# Week 6 2015

```Week 6 Assignments and Readings (October 19th – October
25th)
APSC 100 Mod 1
D2L Homework
Pre-Studio Quiz Conditionals due Monday October 26th 10:30 am.


APSC 100 Mod 2
MEA 1 due Sunday November 1st
Electrical Safety due Oct. 23rd (you need to submit the certificate to the
dropbox on D2L)
 WHMIS due Oct 23rd
 Week 5 survey due Oct 25th
Complete pre-lab for lab (see rotation sheet) in time for week 7 lab period.
Project Selection due October 29th at 5pm (only one person per group has to
submit it)
APSC 111
Partial Formal lab report due for some labs (check rotation sheet) before the start
of your lab period. Don’t forget to sign the honesty statement on the hardcopy
MasteringPhysics
Assignment 5 due for Wednesday October 22rd by 11:00 pm
• Chapter 5: Applying Newton’s Laws
APSC 131
MasteringChemistry
3.2 Thermodynamics is for practice only!!
Lecture homework
Lecture 4.1: Light and Matter
 Problems Chapter 8: 2, 4, 9, 11, 18, 19, 25, 29, 36
Lecture 4.2: A Better Model
 Problems Chapter 8: 41, 46, 47, 49, 51, 58, 62
APSC 171:
Lecture 4.3: Orbitals
• Problems Chapter 9: 4, 6, 8, 10, 13, 16, 18
Moodle Quiz
Week 6 online quiz due Thursday Oct 23rd 11:55 pm.
Practice Problems from textbook:
7th edition
Section 5.3: # 19-37, 39-44, 45-48, 80
Section 5.4: # 1-4, 5-12, 15-18, 21-39, 49-50, 51-57, 63-68
6th edition
Section 5.3: # 19-33, 35-42, 43-46, 76
Section 5.4: # 1-4, 5-12, 15-18, 21-39, 47-48, 49-55, 61
ASPC 161
MIDTERM:
(sketching)
Week of October
26th
(lab period)
COURSE PROJECT:
TASK 2: Component Solid Models due week of November 3rd during lab period.
REQUIRED HOMEWORK
(due in Week 8 studio time):
D.13.D:
 Create a Part model of the Roller (see Moodle for picture)
 Use the D.13.D drawing in workbook for dimensions
 Create a Draft drawing of the Roller from the model
 Show front, side and isometric views on the drawing
 Print out the drawing
Note: All dimensions in inches
(4th ed.)
6.0 - 6.7 Intro, Section Views, Half Sections
6.11 - 6.13 Offset Sections, Ribs, Aligned Sections
(3rd ed.)
7.0-7.8 Section Views, Half Sections
7.12-7.14 Offset Sections, Ribs, Aligned Sections
ASPC 151
Recommended:
D.5.E - Create model in SE Part module &amp; create from it three principal views +
isometric in Draft module