Lab 2
a. 6.4.1 (Basic VLSM Calculation and Addressing Design)
Learning Objectives


Determine the number of subnets needed.
Determine the number of hosts needed. for each subnet.



Design an appropriate addressing scheme using VLSM.
Assign addresses and subnet mask pairs to device interfaces.
Examine the use of the available network address space.
b. 6.4.3 (Troubleshooting a VLSM Addressing Design)
Learning Objectives



Discover errors in a VLSM design.
Propose solutions for VLSM design errors.
Document the corrected VLSM assignments.
c. 6.4.4 (Basic Route Summarization)
Learning Objectives:
• Determine summarized routes that can be used to reduce the size of routing
tables.
Unable to finish task as interface s0/1/0 don’t exist on HQ router. Got s0/2/0 instead and don’t get score
points for that one.
d. 6.4.6 (Troubleshooting Route Summarization)
Learning Objectives:



Discover errors in route summarization.
Propose solutions for summarized routes.
Document the corrected summarized routes.
e. 4.7.1.3 (or Ch4 - Packet Tracer Skills Integration Challenge from Packet
Tracer Student Lab Manual)
This activity focuses on subnetting skills, basic device configuration and static routing.
Once you have configured all devices, you will test for end-to-end connectivity and
examine your configuration.
Learning Objectives:





Design and document an addressing scheme based on requirements.
Select appropriate equipment and cable the devices.
Apply a basic configuration to the devices.
Configure static and default routing.
Verify full connectivity between all devices in the topology.
f. 5.7.1.3 (or Ch5 - Packet Tracer Skills Integration Instructions Challenge from
Packet Tracer Student Lab Manual)
Introduction:
This activity focuses on subnetting skills, basic device configurations, static routing
and RIP routing. Once you have configured all devices, you will test for end-to-end
connectivity and examine your configuration.
Objectives:







Design and document an addressing scheme based on requirements.
Apply a basic configuration to the devices.
Configure static routing between ISP routers.
Configure RIPv1 routing in Region 1 and Region 2
Disable RIP updates on appropriate interfaces
Configure default routes and redistribute through RIP
Verify full connectivity between all devices in the topology.
g. 6.5.1.3 (or Ch6 - Packet Tracer Skills Integration Instructions Challenge from
Packet Tracer Student Lab Manual)
Introduction:
This activity focuses on subnetting skills with VLSM, basic device configurations, static routing and RIP
routing. Once you have configured all devices, you will test for end to end connectivity and examine your
configuration.
Objectives
• Design and document an addressing scheme based on requirements.
• Apply a basic configuration to the devices.
• Configure static routing between ISP routers.
• Configure RIPv2 routing in Region 1 (commands provided) and static routing Region 2