May-14
TEST REPORT TEMPLATE FOR AIR-CONDITIONER MODELS
(AIR-ENTHALPY METHOD)
[COVER PAGE TO BE PRINTED ON TESTING LABORATORY’S COMPANY LETTERHEAD]
Test Report for Air-Conditioner [Model Number]
[Test report reference number]
Section 1: Testing Laboratory
a) Date of test (dd/mm/yy)
b) Name of testing laboratory
c) Location of testing laboratory
d) Name and designation of testing officer
e) Name and designation of approving officer
Section 2: Product Specification1
a) Brand
b) Type
c) Phase
d) Climate type
e) Country of origin
f) Type of refrigerant
g) Total refrigerant charge (kg)
h) Model number
i) Voltage (V)
j) Frequency (Hz)
k) Current (A)
l) Weight (kg)
m) Overall dimensions (h x w x d) (mm)
n) Crankcase heater (W)
o) Rated total cooling capacity at 100% load & 50% load (W)
p) Rated power input at 100% load & 50% load (W)
Section 3: Cooling Capacity Test
a) Test standard
b) Test method
Air enthalpy
100% load
c) Applied voltage(s) (V)
d) Frequency (Hz)
e) Current (A)
f) Duration of test (hr)
g) Total cooling capacity (W)
h) Sensible cooling capacity (W)
i) Latent cooling capacity (W)
j) Effective power input to equipment or individual power inputs to each of
the electrical equipment components (W)
k) Total power input to equipment and its components (W)
1 For
2
split type air-conditioners, data for indoor and outdoor units must be included
For split type inverter air-conditioners only
50% load2
May-14
100% load
50% load2
l) Coefficient of Performance (COP) (W/W)
m) Lowest COP3 (Yes/No)
n) Barometric pressure (kPa)
o) Fan speed setting (RPM)
p) Indoor-side air-flow (m3/s of standard air)
q) External resistance to air-flow for each indoor unit (Pa)
r) Volume flow rate of air and all relevant measurements for its calculation
(m3/s)
s) Dry-bulb temperature of air entering equipment (ºC)
t) Wet-bulb temperature of air entering equipment (ºC)
u) Dry-bulb temperature of air leaving measuring device (ºC)
v) Wet-bulb temperature of air leaving measuring device (ºC)
w) Outdoor dry-bulb and wet-bulb temperatures (ºC)
x) Setting of variable capacity compressor
Section 4: Energy consumption test (Standby mode)
a) Test standard
Measured value
b) Voltage (V)
c) Frequency (Hz)
d) Ambient temperature (ºC)
e) Standby Power4 (W)
f) Procedure for Standby Power testing (E.g. 5.3.2 or 5.3.3 or 5.3.4 of IEC
62301:2011)
Section 5: Signatures


Name and signature of testing and approving officers
Date
Appendix A – Photos



Color photos showing the exterior and interior of the registered model in the available finishing and
colors
Color photo showing the number of connectors on the outdoor unit
Color photo of the nameplate
Appendix B – Schematic Drawing

Schematic drawing clearly indicating the model’s key internal components
Appendix C – Component List

Technical specification and description of the model’s key internal components
3Tested
4
with compatible indoor units that will result in lowest COP
For indoor and outdoor units
May-14
Appendix D – Table Showing the Ratio of the Total Cooling Capacity of the Indoor Units to the
Cooling Capacity of the Outdoor Unit
Model no.
Full/Part load
Outdoor unit
1
Cooling capacity (kW)
Indoor unit
2
3
4
5
Total
Ratio