Dyna-Screen MSDS - Big D Industries

advertisement
Material Safety Data Sheet
Big D Dyna-Block ; Big D Dyna-Screen
1. PRODUCT AND COMPANY IDENTIFICATION
Product Name
Product Identifier
MSDS No.
Other Means of
Identification
Big D Dyna-Block ; Big D Dyna-Screen
607, 609, & 619
0157
Dyna-Block ; Dyna-Screen
Product Family
Manufacturer
Camphor
Big D Industries, Inc., 5620 SW 29th St, Oklahoma City, OK, 73179, 405 682 2541,
BigDInd.com
Big D Industries, Inc., 5620 SW 29th St, Oklahoma City, OK, 73179, 405 682 2541,
BigDInd.com
Big D Industries, 800 535 5053, 24hr (Infotrac)
Supplier
Emergency Contact
Information
Use
Dry Deodorants
2. HAZARDS IDENTIFICATION
Emergency Overview
Colourless white crystalline crystals. Aromatic odour. FLAMMABLE SOLID.
Potential Health Effects
Route of Exposure
Inhalation
Skin Contact
Eye Contact
Ingestion
Effects of Long-Term
(Chronic) Exposure
Inhalation; skin contact; eye contact; ingestion.
Can irritate the nose and throat.
May cause mild irritation.
May cause moderate to severe irritation.
Can irritate the mouth, throat and stomach.
TOXIC.
Carcinogenicity
Possible carcinogen.
Teratogenicity /
Embryotoxicity
No information was located.
Reproductive Toxicity No information was located.
Mutagenicity
No information was located.
Potential Environmental Effects
Product and/or byproducts are not likely to bioaccumulate.
3. COMPOSITION/INFORMATION ON INGREDIENTS
Chemical Name
CAS No.
Concentration %
Camphor
ISOBORNEOL
76-22-2
124-76-5
90-100
5-10
MSDS Name:
Big D Dyna-Block - Ver. 1
MSDS No.:
0157
Date of Preparation:
February 04, 2013
Other Identifiers
Page 01 of 06
4. FIRST AID MEASURES
First Aid Procedures
Inhalation
Move victim to fresh air. Call a Poison Centre or doctor if the victim feels unwell.
Skin Contact
Take off contaminated clothing, shoes and leather goods (e.g. watchbands, belts). Wash gently
and thoroughly with lukewarm, gently flowing water and non-abrasive soap for 5 minutes. Call
a Poison Centre or doctor if the victim feels unwell.
Immediately flush the contaminated eye(s) with lukewarm, gently flowing water for 15-20
minutes, while holding the eyelid(s) open. If irritation or pain persists, see a doctor.
NEVER give anything by mouth if victim is rapidly losing consciousness, or is unconscious or
convulsing. DO NOT INDUCE VOMITING. Have victim rinse mouth with water. Immediately
call a Poison Centre or doctor.
If exposed or concerned, see a doctor for medical advice.
Eye Contact
Ingestion
First Aid Comments
5. FIRE FIGHTING MEASURES
Flammable Properties FLAMMABLE SOLID.
Suitable Extinguishing Small fire: Carbon dioxide, dry chemical powder, appropriate foam, water spray or fog.
Media
Large fire: Use flooding quantities of water spray or fog.
Unsuitable
Extinguishing Media
None known.
Specific Hazards
Arising from the
Chemical
Gas or vapour may travel a considerable distance to a source of ignition and flash back to a
leak or open container.
In a fire, the following hazardous materials may be generated: very toxic carbon monoxide,
carbon dioxide.
Protective Equipment Use extreme caution.
and Precautions for
Firefighters should enter area wearing specialized protective equipment. (Bunker Gear will not
Firefighters
provide adequate protection.).
6. ACCIDENTAL RELEASE MEASURES
Personal Precautions Use the Personal Protective Equipment recommended in Section 8 of this MSDS. Increase
ventilation to area or move leaking container to a well-ventilated and secure area. Eliminate all
ignition sources. Use grounded, explosion-proof equipment.
Environmental
If the spill is inside a building, prevent product from entering drains, ventilation systems and
Precautions
confined areas. Do not allow into any sewer, on the ground or into any waterway.
Methods for
Containment and
Clean-up
Stop or reduce leak if safe to do so. Store recovered product in suitable containers that are:
tightly-covered.
7. HANDLING AND STORAGE
Handling
Storage
Avoid repeated or prolonged skin contact with product or with contaminated
equipment/surfaces. Only use where there is adequate ventilation. Avoid generating dusts.
Avoid generating vapours or mists. Eliminate heat and ignition sources such as sparks, open
flames, hot surfaces and static discharge. Post "No Smoking" signs.
Store in an area that is: dry, well-ventilated, out of direct sunlight and away from heat and
ignition sources, separate from incompatible materials (see Section 10: Stability and
Reactivity).
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure Guidelines
MSDS Name:
Big D Dyna-Block - Ver. 1
MSDS No.:
0157
Date of Preparation:
February 04, 2013
Page 02 of 06
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure Guidelines
ACGIH TLV®
Chemical Name
TWA
STEL
OSHA PEL
TWA
Ceiling
AIHA WEEL
8-hr TWA
TWA
Camphor
12 mg/m3
19 mg/m3 2 mg/m3
Engineering Controls Use local exhaust ventilation, if general ventilation is not adequate to control amount in the air.
Personal Protective Equipment (PPE)
Eye/Face Protection
Wear chemical safety goggles.
Skin Protection
Prevent skin contact.
Respiratory Protection Do not breathe in this product.
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical State
Appearance
Odour
Odour Threshold
Molecular Formula
Molecular Weight
Boiling Point
Melting Point
Freezing Point
Relative Density (water = 1)
Solubility in Water
Solubility in Other Liquids
pH
Partition Coefficient,
n-Octanol/Water
Solid
Colourless white crystalline crystals.
Aromatic
Causes olfactory fatigue.
Not applicable
Not applicable
Not available
356 - 417 ºF (180 - 214 ºC) (estimated)
356 - 417 ºF (180 - 214 ºC) (estimated)
Not available
Slightly soluble
Highly soluble in ketones (e.g. acetone).
Not applicable
Not available
Vapour Pressure
Saturated Vapour Concentration
Critical Temperature
Vapour Density (air = 1)
Evaporation Rate
Flash Point
Lower Flammable/Explosive
Limit
Not applicable
1267 - 1681 ppm
Not available
5.24
Not available
150.1 ºF (65.6 ºC) (closed cup) (Camphor)
0.6% (Camphor)
Upper Flammable/Explosive
Limit
3.5% (Camphor)
Auto-ignition Temperature
~ 873 ºF (467 ºC) (Camphor)
10. STABILITY AND REACTIVITY
Chemical Stability
Conditions to Avoid
Incompatible
Materials
Hazardous
Decomposition
Products
Possibility of
MSDS
Name:Reactions
Hazardous
Normally stable.
None known.
Oxidizing agents (e.g. peroxides), strong oxidizing agents (e.g. perchloric acid), acid
anhydrides (e.g. acetic anhydride), organic acids (e.g. acetic acid).
Very toxic carbon monoxide, carbon dioxide.
None known.
Big D Dyna-Block - Ver. 1
MSDS No.:
0157
Date of Preparation:
February 04, 2013
Page 03 of 06
Possibility of
None known.
Hazardous Reactions
11. TOXICOLOGICAL INFORMATION
LC50/LD50 Values
Chemical Name
Camphor
LC50
ISOBORNEOL
Skin Irritation/Corrosion
LD50 (oral)
1310 mg/kg (mouse)
LD50 (dermal)
5200 mg/kg (rat)
5000 mg/kg (rabbit)
Animal tests show moderate or severe irritation following prolonged exposure (24 hours).
Eye Irritation/Corrosion
There is limited evidence of mild irritation. (Camphor)
Effects of Short-Term (Acute) Exposure
Inhalation
May be harmful based on limited evidence. Causes nose and throat irritation. May cause lung injury.
Skin Absorption
May be harmful.
Ingestion
May be harmful based on limited evidence. Irritation of the mouth, throat and stomach, harmful effects on the kidneys,
harmful effects on the liver.
Effects of Long-Term (Chronic) Exposure
No information was located.
Respiratory and/or Skin Sensitization
No information was located.
Carcinogenicity
A4 – Not classifiable as a human carcinogen.
Key to Abbreviations
ACGIH® = American Conference of Governmental Industrial Hygienists. A4 = Not classifiable as a human carcinogen.
Teratogenicity / Embryotoxicity
May cause effects on the unborn child based on information for closely related chemicals.
Reproductive Toxicity
No information was located.
Mutagenicity
Not mutagenic. Animal studies show evidence of mutagenicity in reproductive cells (sperm or eggs).
Toxicologically Synergistic Materials
No information was located.
12. ECOLOGICAL INFORMATION
General Comments
Environmental information was not located.
13. DISPOSAL CONSIDERATIONS
The required hazard evaluation of the waste and compliance with the applicable hazardous waste laws are the
responsibility of the user.
MSDS Name:
Big D Dyna-Block - Ver. 1
MSDS No.:
0157
Date of Preparation:
February 04, 2013
Page 04 of 06
14. TRANSPORT INFORMATION
Shipping Information
Regulation
UN No.
Shipping Name
Class
Packing
Group
Canadian TDG 1325
Flammable solids, organic, n.o.s. (Flammable Solid
Fragrance)
4.1
III
US DOT
Flammable solids, organic, n.o.s. (Flammable Solid
Fragrance)
4.1
III
1325
Other Transport Information
Special Shipping
Information
Please note: US DOT Exceptions: LTD QTY (See CFR)(Ground) See 40 CFR for Quantity
Limitations by other modes.
15. REGULATORY INFORMATION
Canada
WHMIS Classification
Class B3
Class D2B
B3 - Combustible Liquid; D2B - Toxic
This product has been classified in accordance with the hazard criteria of the Controlled Products Regulations and the
MSDS contains all of the information required by the Controlled Products Regulations.
Domestic Substances List (DSL) / Non-Domestic Substances List (NDSL)
All ingredients are listed on the DSL or are not required to be listed.
USA
US OSHA Regulatory Status
This material is considered hazardous by the OSHA Hazard Communication Standard (29 CFR 1910.1200 (1994)).
Toxic Substances Control Act (TSCA) Section 8(b)
All ingredients are on the TSCA Inventory or are exempt from TSCA Inventory requirements under 40 CFR 720.
Additional USA Regulatory Lists
SARA Title III - Section 311/312: Fire Hazard acute health hazard
Rhode Island RTK hazardous substances. (Camphor)
Pennsylvania Right To Know. (Camphor). (ISOBORNEOL)
Minnesota. (Camphor)
Florida. (Camphor)
Massachusetts Right To Know. (Camphor)
New Jersey Right To Know. (Camphor). (ISOBORNEOL)
California Director's List of Hazardous Substances (8 CCR 339). (Camphor)
Tennessee. (Camphor)
Custom Regulatory 1
This Product may not be sold for use in the following US states: California Michigan Maryland Delaware Pennsylvania
New Jersey Connecticut Rhode Island Massachusetts Maine District of Columbia New York
16. OTHER INFORMATION
NFPA Rating
MSDS Prepared By
Health - 0
Flammability - 3
Wayne Hegstrom
MSDS Name:
Big D Dyna-Block - Ver. 1
MSDS No.:
0157
Date of Preparation:
February 04, 2013
Instability - 0
Page 05 of 06
MSDS Prepared By
Phone No.
Date of Preparation
Revision Indicators
Health - 0
Flammability - 3
Instability - 0
Wayne Hegstrom
405 682 2541
February 04, 2013
The following MSDS content was changed on December 11, 2014:
(English MSDS); (French MSDS); (Spanish MSDS); Product Name; Product Identifier; Other
Means of Identification.
MSDS Name:
Big D Dyna-Block - Ver. 1
MSDS No.:
0157
Date of Preparation:
February 04, 2013
Page 06 of 06
Download