KYRENIA UNIVERSITY MARITIME FACULTY GRADUATION

advertisement
KYRENIA UNIVERSITY
MARITIME FACULTY
GRADUATION PROJECT GUIDE
GÜNER BUĞRAHAN
1
KYRENIA UNIVERSITY
MARITIME FACULTY
1. GRADUATION PROJECT REGISTRATION
The concept of graduation project will be selected by the student according to his /her subject. If the
project is granted by the supervisor with whom the student wants to work, The `Graduation Project
Approval Form` appendix-9 will be issude by the chairman.
The subject should be selected during the courses registration.
While searching the relevant subjects of project, the foundings should be based upon scientific paper,
books and puplications etc. The information from unauthorised authors or text should not be taken into
consideration.
2.
PREPARATION OF GRADUATION PROJECT
The project must be prepared according to the following rules. Guidelines of the project that is going to be
prepared by the student, is controlled by the supervisor.
3. DELIVERY OF THE PROJECT
The project will be two copies, with a hardcover and has to be heanded over to the supervisor no
later than 10 days after the final exams of that semestre.
4. PROJECT GUIDLINES
i
ii
iii
iv
v
vi
COVER PAGE
THE APPROVAL OF PROJECT PAGE
ACKNOWLAGEMENT
ABSTRACT
LIST OF TABLES
LIST OF FIGURES
vii LIST OF GRAPHS
viii ABBREVIATIONS
ix TABLE OF CONTENTS
x INTRODUCTION
xi CHAPTERS
xii CONCULUSIONS AND RECOMMENDATIONS
xiii REFERENCES
xiv APPENDICES
2
5. TEXT CONFIGURATION
The student, should give great attention to choose the sentences in order to make the subject to be
understood by the readers. Short and meaningful sentences are advisable to use for expressing exact
meaning of what he/she means. The project have to be composed of minimum 30 and maximum 100 pages.
The pages should be on A4 size paper and only one side should be used.The text character size will be 12,
“The New Romans” and “Justified”. Headings are in “Bold” and 14 in character size. A space will be given
after fullstop and commas. When an abbreviation is used it has to be written in uppercase and explanation
should be written in the “ABBREVIATIONS “ page.
6. PAGE ARRANGEMENT
In between lines as well as after headers 1.5 space is to be used. Upper and right margins are 2.5 cm.
Bottom and left margins are 3 cm. The font size of main headers will be 14 “Bold” and
uppercase.(example: CHAPTER 1:PHOTOELECTRIC EFFECT). The headers size 12 (example:1.1
Absorption and Emmission of photon). The sub headers size 12(example: 2.1.1 The Electric Energy
Storage) as it is shown in appendix-6. Page number will be centered at the bottom of the page. The
emphasized word or centences have to be writen in italic.
The title of the table, size 12, must be written on the top of tables, whereas the title of figures and graphs
are written at the bottom.
Voltage in volts
Example for graphs.
t
Time in seconds
1.5 line spacing
Graph 2.1 sinusoidal wave forms.
………………………………………………………………..text………………………………………………………
3
Example for table configuration.
..............................................text......................................................
Table 4.3 Some of Metric (SI) Multipliers
1.5 line spacing
1.5 line spacing
Prefix
exam
peta
tera
giga
mega
kilo
mili
micro
nano
pico
femto
atto
Abbreviation Value
E
1018
P
1015
T
1012
G
109
M
106
k
103
m
10-3
µ
10-6
n
10-9
p
10-12
f
10-15
a
10-18
i. COVER PAGE
The cover page will be in two copies, one of them will be hardcover and the other will be the
first page on A4 paper of the Graduation Project. The sample is in Appendix-1. The sample of
“Spine Article” is shown in appendix-1.1
ii. THE APPROVAL OF PROJECT
The sample is at appendix-9. The page number will be “i”
iii. ACKNOWLEDGEMENT
In this part the student expresses his/her appreciations to his/her supervisor, Instructors and
other people who have had contribution to the project. The page number will be “ii”.
iv. ABSTRACT
The content and the purpose of the project should be summarized not more than 150 words.
The page number will be “iii”. In this section at least three key words have to be given.
v. LIST OF TABLES
See appendix-2 The page number will be “iv”.
The title of the table must be written on top of the tables, whereas the title of figures and graphs are at the
bottom.
vi. LIST OF FIGURES
See Appendix-3. The page number will be “v”
vii. LIST OF GRAPHS
See Appendix-4. The page number will be “vi”
viii.
ABBREVIATIONS
See Appendix-5. The page number will be “vii”
ix. TABLE OF CONTENTS
Refer to Appendix 6. No page number.
4
x. INTRODUCTION
In this section, the project is to be summarised very briefly.The importancy, the aim and the goal of the
project should be briefly described.
Finally, at the last paragraph of introduction contents of the chapters must be summarized very shortly.
The page number will start with 1.
xi.
CHAPTERS
The page number will start with 2 and will continues till the end of “REFERANCE”. In this section the number
of the chapters should be writen as “CHAPTER 1:(The name of chapter). In the chapters the relevant theories
mast be explained scientifically. The relevant sources of the project should be numbered in square bracket such
as [1]......[5] and those numbers will be named in “REFERANCES”, so that it can be comprehensible, which
number presents which source.
Formulae which is going to be used will be numbered
according to chapters. That is to say:
Eq.2.4
Indicates that this formula is the fourth formula and it belongs to chapter two. The units should be in SI units.
xii CONCULUSION AND RECOMMENDATIONS
Conculusion will be the last chapter of project.This part of the project is very important section of the
project. Hence, it has to be considered carefully and a great attention has to be paid. The corollary of the
suggestions or the applications depending on theories should be stated in the conclusion part. Has the basic goal,
which was mentioned in “INTRODUCTION” section, been completely or partly reached? If it is partly reached,
the reasons must be stated.
Suggestions for improving the project must be stated by the student in “recommendation” paragraph.
xiii REFERENCES
Sources: The supervisor suggests to the student to search relevant sources relating to his/her project and
have those sources to be authorized by the supervisor and those which have been authorized must be listed
in Appendix-7.
.
xiv. APPENDICES
If one appendix or more than one appendices will be established, the example can be seen in appedix-8
EXPERIMENTAL SETUP
If the project contains an experimental setup, the setup will be given in details, and relevant figures and
photographs must be included in graduation project
5
Appendix-1(Example for Cover and Title Pages)
KYRENIA UNIVERSITY
(Time New Roman 20 Bold)
FACULTY OF MARITIME STUDIES
(Arial
Bolt)
(Time20
New
Roman 20 Bold)
MARITIME TRANSPORTATION MANAGEMENT
ENGINEERING
(Time New Roman 20 Bold)
(The name of project):..........................................
(The Name of Project Time New Roman 25 Bold in Block Letter)
Prepared By: (Name surname)
(Time New Roman 18 Bold)
Supervisor: .....................
(Time New Roman 18 Bold)
KYRENIA-2016
(Time New Roman 16
6 Bold)
EK1.1 Spine Article
(Name Surname)
(Project Name)
KU2016
7
Appendix-2 Every list should be started on a new page
LIST OF TABLES
Page Number
Table 4.3. Some of Metric (SI) Multipliers
25
Table ... .......................................
...
Appendix-3
LIST OF FIGURES
Page Number
Figure 1.1.1. ...........................................
...
Figure 3.1. ............................................
...
Appendix-4
LIST OF GRAPHS
Page Num
...
...
Graph 2.1. Sinusoidal waveform
Graph 3.2. .............................
Appendix-5
ABBREVIATIONS
KVL: Kirchhoff’s Voltage Law
.... : ..........................
8
Appendix-6 (Example for Table of Contents)
TABLE OF CONTENTS
THE APPROVAL OF PROJECT
ACKNOWLAGEMENT
ABSTRACT
ÖZET
LIST OF TABLES
LIST OF FIGURES
LIST OF GRAPHS
ABBREVIATIONS
......................................................................................
…………………………………………………………………………………...
……………………………………………………………………………………
……………………………………………………………………………………
......................................................................................
……………………………………………………………………………………
……………………………………………………………………………………
……………………………………………………………………………………
INTRODUCTION
i
ii
iii
iv
v
vi
vii
viii
1
CHAPTER1:PHOTOELECTRIC EFFECT
1.1
1.2
Absorption and Emission of Photon
Energy Emmission
1.2.1 Excited Electrons
………………………………………………………………………….
………………………………………………………………………….
………………………………………………………………………….
2
5
CHAPTER 2: SOLAR ENERGY
2.1
2.2
Solar Panel
Storage of Energy
2.1.1 …………………..
………………………………………………………………………….
………………………………………………………………………….
………………………………………………………………………….
CHAPTER 3: USAGE OF SOLAR ENERGY IN MARITIME
3.1 ……………………………..
3.2 ………………………………
3.2.1 ……………………
3.2.2 …………………..
3.1.1 ………………..
………………………………………………………………………………………
……………………………………………………………………………………….
………………………………………………………………………………………
………………………………………………………………………………………
………………………………………………………………………………………
CHAPTER 4: CONCULUSIONS AND RECOMMENDATIONS ………………………. 99
……………………………………………………………………………………… 100
REFERENCES
APPENDICES
Appendix A:
Appendix B:
………………………………………………………………………………………
………………………………………………………………………………………
9
102
105
Appendix-7 (Example for Referances)
REFERANCES
(Sources of Internet)
[1]. http://www.iis.ee.ic.ac.uk/~frank/surp00/article1/cfcs98/
[2]. www.amp.ucdavis.edu/DIP/PDF/DIP-1-Introduction.pdf
.
(Books or Periodic)
Author(s) (Name Surname), Book Title, Publisher, Date
[3] Douglas C.Giancoli.,”Physics For Scientists &
River,NJ,07458,1984.
[4]
.........................................................
[5]
.........................................................
10
Engineers”,Prentice
Hall
Upper
Saddle
Appendix-8 Sample of Appendices.
Each appendix should be started on a new page
Appendix A. Tables
Table A.1 Conversion of Force
N
Lb
1 Newton
1
0.2248
1 Pound
4.448
1
TABLE A.2
Length
Hass
Time
Electric Current
Temperature
SI Units
Meter
Kilogran
Second
Amper
Kelvin
m
Kg
s
A
K
Appendix B
B.1 TRIGONOMETRY
Sinα=Cos(90-α)
Cosα=Sin(90-α)
Sin(A±B)=SinACosB±CosASinB
Cotα=Tan(90-α)
Cos(A-B)=CosACosB + CosASinB
Cos(A+B)=CosACosB - CosASinB
B.2 LOGARITHMS
Log(ab)=Loga+Logb
Log(a/b)=Loga-Logb
Log an=nLoga
11
Appendix-9 (Example for Graduation Project Approval Form)
Graduation Project must be delivered at list one week before dead line of submission
date.
Date:…./....../.......
GRADUATION PROJECT REGISTRATION FORM
Department of ………………….
………………………....Semester
I herewith certify that I accept all the condition below and the subject of the project has been determined with
the approval of supervisor.
Code of the Course :.......................
Graduation Project Title:………………………………………………………………….
………………………………………………………………………………………………
Student’s
No:………………Name:…………………………………………………………
Surname…………………………………...........................Signature:............................
Supervisor:.......................................................................................Signature:.........................
12
Download