The Construction Of Two Feet Electronics Fluorescent Lamp
TABLE OF CONTENT
Title Page
Dedication
Acknowledgement
Preface
Table of Content
Abstract
CHAPTER ONE
1.0
INTRODUCTION
CHAPTER TWO
2.0
Literature Review
2.1
Component Description
2.2
Capacitor
2.2.1 Characteristic of Capacitors
2.3
Resistor
2.4
Transformer
2.5
Transistor
2.6
Diode
CHAPTER THREE
3.0
Principle of Operation
3.1
Block Diagram
3.2
Circuit Diagram
3.3
Wiring Diagram
CHAPTER FOUR
4.0
CONSTRUCTION
4.1
How the Construction was Made
4.2
Construction of the Chassis (Casing)
4.3
Flat Pattern Drawing of the Chassis
4.4
Tools used During Construction
CHAPTER FIVE
5.0
TESTING & RESULT
CHAPTER SIX
6.0
RECOMMENDATION AND CONCLUSION
6.1
Recommendation
6.2
Conclusion
6.3
Reference
CHAPTER ONE
1.0
INTRODUCTION
1.1
In circuit time, much of the indoor work done by human depended up
day light of sun being available, which was created by God as the first
thing.
Today almost all building have electric lighting installed and all indoor and out
of door work can be done at any time of the day or night.
Good lightering provides safety, efficient work and comfortable surrounding
lighting scheme are designed using different types of light fitting or luminous
in modern term to control the distribution of light.
Due to the importance of lighting, I am introducing a two feet electronic
fluorescent lamp, which shall be able to supply light energy at any particular
time of the day or night as the need may be.
The fact that our present electric power supply has been characterized by
constant low power output, the two feet electronic fluorescent lamp found its
greater advantage in many place such as surgical room, school library and
industrial system where clear vision is needed for safety purpose.
The present high demand for electronic fluorescent lamp becomes one of major
sources of foreign exchange earning for this country (Nigeria).
1.2
THE PURPOSE / OBJECTIVE / AIM OF THE PROJECT
The major aim of the project and reasons for choosing to build art two feet
fluorescent lamp and not any other project are:i.
For knowledge sake
ii.
To help the society by production
iii.
To be able to maintain repair and damaged fluorescent lamps.
iv.
To be able to design circuit diagram
1.3
THE SCOPE OF THE PROJECT
The scope of the project is the ability to do or achieve the project. The scope
also include the step, which intended in executing the project. These steps are:i.
I make the problem clear
ii.
I think up ideas to the problem
iii.
I develop solutions to the problem
iv.
I make or model the solution
v.
I see if the solution will solve the problem.
*** INSTRUCTIONS ***
Please Read The Below Instructions Carefully.
******************************
HOW TO ORDER THIS COMPLETE MATERIAL
If you want to order the complete materials (Chapter One
to Five, Including Abstract, References, Questionnaires, Proposal (where
applicable)) of the above mentioned topic, please visit
www.freeplace.org and click on “Order” (i.e.
www.freeplace.org/order)
******************************
HOW TO BECOME OUR PARTNER
To become our partner, visit www.freeplace.org and click on
partnership.
******************************
TERMS OF USE
This Material is for Academic Research Purposes only. On no
account should you copy this material word for word. Copying
this material “Word for Word” is against our “Terms of Use”.
That you ordered this material shows you have agreed Our
‘Terms of Use’.
******************************
Better is not good enough, the best is yet to come!
Endeavour to be the best!!