“Name of the project”
2014-2015
A Dissertations Submitted to
Rajiv Gandhi Proudyogiki Vishwavidyalaya
For partial fulfillment of the
Degree of Bachelor of Engineering
In
Electronics & Communication Engineering
Under the Guidance of:
Submitted by:
Mr. (Name of the Faculty)
( Designation Like Lecturer
(Name of students with Enrollment No)
Xxxxxxxxxxxxxx (0805EC0XXXX)
, Assistant Professor etc.) Xxxxxxxxxxxxxx (0805EC0XXXX
Xxxxxxxxxxxxxx (0805EC0XXXX
Department of Electronics & Communication Engineering
JAWAHARLAL INSTITUTE OF TECHNOLOGY
BORAWAN (KHARGONE), M.P. -451228
JAWAHARLAL INSTITUTE OF TECHNOLOGY
BORAWAN (KHARGONE), M.P.
CERTIFICATE
This is to certify that project entitled “Name of the project” is
submitted by “name of the each student ( group member)” students of
Final Iyear of “Electronics & Communication Engineering” year 20142015 in partial fulfillment of the requirements of “Rajiv Gandhi
Proudyogiki Vishwavidyalaya Bhopal” For partial fulfillment of the
Degree of Bachelor of Engineering in Electronics & Communication
Engineering from “Jawaharlal Institute of Technology ,Borawan”, under
R.G.P.V. BHOPAL (M.P.)
(Name of Guide)
Project Guide
Sanjay Chouhan
Head of Department
Dr. Atul Upadhyay
Principal
JAWAHARLAL INSTITUTE OF TECHNOLOGY
BORAWAN (KHARGONE), M.P.
CERTIFICATE OF APPROVAL
This is to certify that project entitled “NAME OF PROJECT” is
submitted by “name of the each student ( group member)” in partial
fulfillment of the requirements for the award of Bachelor of Engineering in
Electronics & Communication Engineering during the academic year 20142015 from “Jawaharlal Institute of Technology”, Under R.G.P.V.
BHOPAL (M.P.)
External Examiner:
Internal Examiner:
ACKNOWLEDGEMENT
Name of student
Abstract
What you have done in your project and how it is beneficial.
(Min 3 or 4 paragraph) not more then one page. (In Bold letter ,Time New Roman font
12)
Table of Contents
Page No.
Chapter-1 INTRODUCTION
1.1 Problem Formulation
1.2 Main challenges
1.3 Proposed Solution
1.4 Benefits of Proposed System
Chapter-2 TECHNOLOGY USED (Introduction of all Technology used like H/D,
Module and related content.)
Chapter- 3 HARDWARE IMPLEMENTATION
3.1 Circuit Components
3.2 PCB Layout
3.3 PCB Design Techniques
3.4 Block Diagrams of Circuit
3.5 Description of Block Diagrams/Flow diagram
3.6 Circuit Diagrams with Description
Chapter- 4 SOFTWARE IMPLEMENTATION
4.1 Tools used
4.1 Flow Chart
Chapter-5 CONCLUSION
5.1 Advantages
5.2 Limitations
5.3 Application of Project
5.4 Future Enhancement
REFERENCES
(Reference must be written in [1] ,[2] like)
APPENDIX-A

List of Table

List of Figures

List of Abbreviation
APPENDIX-B

How to run Project? (Stepwise)
Font size: (Except Certificate and Content):
1. All fonts name must be Times New Roman.
2. Font size from the chapter must be 12
3. Chapter font size must be 24 (page with chapter name only)
4. Chapter font size must be 18
5. Line spacing must be 1.5
6. Page size (Margin )must be left 1.5”,right-1.0”, top-1.0”, bottom-1.0”
7. Main Heading must be Upper case and bold in 12 font size
8. Subheading must be Title Case in 12 font size
9. Total number of Thesis must be equal to (Total no. of Member + 02).