50 mm
Do not write here
Guidelines for the Preparation of
a Manuscript for ECECON 2016
John. C. Jackson
Jack. E. Johnson
Carlston University
jcjackson@cu.ac.ir
Telecom Research Institute
jejohnson@tri.ac.ir
15 mm
Title Block
22 mm
The paper title should be typed with the first
character in every word in capital letters, centred
and placed 28 mm from the top of the first page.
The title should be bold printed and should not be
underlined. The name(s) of the author(s) and
author affiliation(s) should be centered, with the
Keywords: Conference publication format, guide
first character in every word in capital letters.
to authors.
In the end of the title block and after the author
8mm affiliation(s) the author’s e-mail address must
Do not write here
1.
Introduction
It is our aim to produce uniform conference
proceedings. We would therefore appreciate it
very much if you would prepare your paper in
accordance with the following guidelines. Papers
will not be accepted for process if they are not
prepared in accordance with the required format.
Proportional-spaced fonts (e.g. Roman or
equivalent) should be used in the main body text.
Please try to avoid using mono-spaced fonts (e.g.
Courier). Font sizes are specified in Table 1.
2.
Format
Each manuscript is to be submitted electronically
in pdf format through the ECECON 2016 Online
Conference. Management System (http://www.
Ececon2016.org/submission/online-submission.html).
It is limited to six pages. Your paper should be
submitted on A4 (210 mm x 297 mm) page and
typed in a two-column format as shown in this
template.
Do not write here
2.1
preparation of manuscripts for the first Conference of
Electrical and Computer Engineering (ECECON 2016)
to be held in Bangkok, Thailand in January 2016. This
paper itself is an example of the desired format.
Formats for equations, tables and references are also
presented.
22 mm
be written.
2.2
Abstract and Keywords
A meaningful and concise abstract is required.
The abstract should not exceed 200 words. The
authors should also select up to five keywords to
supplement the title reflecting the subject matter.
2.3
Headings
All headings should commence at the left-hand
margin of the column. Except at the top of a new
page, all headings should be numbered and
preceded by one blank line.
First and Second Order (or Main) Headings should
be typed with the first character in every word
capitalised, boldfaced and followed by one blank
line.
3.
Other Requirements
3.1
Figures and Tables
Do not write here
25 mm
Do not write here
Abstract: This paper provides guidelines for the
25 mm
Do not write here
Effect of Linear Current Density (A) on Efficiency
89
88.5
88
Efficiency-Eta (%)
87.5
87
86.5
86
85.5
85
A1 = 19.0 kA/m
A1 = 18.5 kA/m
A1 = 18.0 kA/m
84.5
84
0.4
0.6
0.8
Output Power/Rated Power (POut/Pun)
1
Fig. 1 A figure spanning two columns
5
 ( X  y
x
1
) 2 dz 
dy
dx
(1)
Citation of the references should be made within
square brackets. For example, book reference [1]
and other references [2, 3] are listed at the end of
the paper.
Fig. 2 A figure of one column width
22 mm
3.2 Equations and References
Equations should be in italics and symbols, and
should be clearly numbered. Reference to the
equations should be in the form of “Equation (2)”.
For example, Equation (1) is Nobody’s Law.
Table 1 is an example of a table. It also illustrates
the font sizes preferred. The entire paper will be
printed in black and white. Hence, please
incorporate figures and tables in black and white
only.
Table 1: Font Sizes in Times New Roman
Size
Usage
10 point
For subscripts and footnotes
10 point
For Figures and Tables
10 point Italic
For Abstract
11 point
For body text
12 point
For headings
11 point
For subtitles
16 point
For main title
The International System of Units should be used.
Please try to balance the height of the two columns
on the last page of the paper
Acknowledgements
The authors would like to express their sincere
thanks to Mr C. C. Secretary for his valuable
comments.
References
25 mm
Do not write here
Do not write here
Figures and tables can occupy either one or two
columns. Figures 1 and 2 are provided as
examples.
[1] A. Author Name1 and B. Author Name2, Title
of the Book. John Wiley & Sons, pp. 100-105,
2014.
[2] A. Author Name1 and B. Author Name2,
“Title of the conference paper,” Proc. Int.
Conf. on Power System Reliability, Singapore,
pp. 100-105, 2000.
[3] A. Author Name1 and B. Author Name2,
“Title of the journal paper” IEEE Trans.
Antennas and Propagation, Vol. 55, No. 1,
pp. 12-23, 2012.
Do not write here
22 mm