Henke RB60-26 Specifications
Yes
Moldboard "face" shall be smooth rolled, 3/16” thick steel, 26 ft. in length. (Break
formed moldboards are unacceptable)
Height of moldboard shall be (minimum) 60"
Moldboard shall be vertically braced by 4" wide x 1/2" thick, plasma cut, steel ribs.
Moldboard bottom angle shall be 4" x 6" x 3/4" (minimum). Unit shall have an
additional, full length, 4” x 6” x ¼” steel tube, which further supports the bottom
angle.
Moldboard shall be braced horizontally by 5” x 5” x 3/8” steel angles welded
between each rib for additional support.
Bolt on, end plates shall be (minimum) 5/8” thick steel plate. Minimum “depth” shall
be 48”; minimum height shall be 58”. End gates shall bolt on with a minimum of (7)
¾” bolts.
End plates shall be reinforced with full length, (horizontal & vertical) 3” x 3” x ¼”
structural steel tube. This structural bracing shall be placed well above cutting
edge, to prevent possible damage from impact.
RB60 runners shall have inset (flush with bottom) a minimum of (4) 3” x 4” x ½”
wear pads for a minimum of 48in2 of wear surface per runner.
Plow shall be designed so that the runners carry the weight of the unit. Weight of
plow shall NOT rest on the runner attaching bolts. Runners shall bolt to end gates
with a minimum of (5) ¾” attaching bolts.
Height of cutting edge above plowing surface shall be adjustable via adding or
removing replaceable washers.
1 ½” x 10” rubber cutting edge provided as standard.
Unit shall have female portion of ACS type coupler
No