MATERIAL SAFETY DATA SHEET
FILE NO.:
MSDS DATE: 06 /28 / 10
E2e Soy Based Resin System
SECTION 1: PRODUCT AND COMPANY IDENTIFICATION
PRODUCT NAME:
SYNONYMS:
PRODUCT CODES:
e2e soy protein based resin system
na
na
MANUFACTURER:
DIVISION:
ADDRESS:
e2e Materials, Inc.
EMERGENCY PHONE:
CHEMTREC PHONE:
OTHER CALLS:
FAX PHONE:
607-342-8886
na
CHEMICAL NAME:
CHEMICAL FAMILY:
CHEMICAL FORMULA:
Protein, polysaccharide
protein, polysaccharide
PRODUCT USE:
PREPARED BY:
The resin is used in composite manufacturing, adhesives
The resin is prepared by mixing soy protein and other proprietary ingredients with water
239 Cherry St
Ithaca, NY 14850
607-272-3369
SECTION 1 NOTES:
SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS
INGREDIENT:
Soy flour
Proprietary Ingredient A
Proprietary Ingredient B
Proprietary Ingredient C
% WT
8
1
1
0.5
% VOL
ppm
mg/m3
SARA 313 REPORTABLE
No
No
No
No
OSHA PEL-TWA:
OSHA PEL STEL :
OSHA PEL CEILING:
ACGIH TLV-TWA:
ACGIH TLV STEL:
ACGIH TLV CEILING:
SECTION 2 NOTES:
Product is not classified as hazardous
SECTION 3: HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW: In case of contact with eyes or skin, rinse thoroughly with water
ROUTES OF ENTRY:
POTENTIAL HEALTH EFFECTS
EYES:
May cause eye irritation
SKIN:
Minimal irritation or reaction expected
INGESTION:
May cause indigestion. No special treatment required.
INHALATION: Not applicable
ACUTE HEALTH HAZARDS: possible eye irritant
CHRONIC HEALTH HAZARDS: None Known
PAGE 1 OF 6
MATERIAL SAFETY DATA SHEET
FILE NO.:
MSDS DATE: 06 /28 / 10
E2e Soy Based Resin System
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: None known
CARCINOGENICITY
OSHA:
OTHER:
ACGIH:
NTP:
IARC:
SECTION 3 NOTES: Not listed as a carcinogen
SECTION 4: FIRST AID MEASURES
EYES: Do not rub eyes. Flush eyes thoroughly with water for 15 minutes. If condition worsens or irritation persists, contact
physician
SKIN: Rinse thoroughly with water
INGESTION: No treatment required.
INHALATION: Not applicable
NOTES TO PHYSICIANS OR FIRST AID PROVIDERS:
SECTION 4 NOTES:
SECTION 5: FIRE-FIGHTING MEASURES
FLAMMABLE LIMITS IN AIR, UPPER: Nonflammable
(% BY VOLUME)
LOWER:
FLASH POINT: Nonflammable
F:
C:
METHOD USED:
AUTOIGNITION TEMPERATURE: Nonflammable
F:
C:
NFPA HAZARD CLASSIFICATION
HEALTH:
0
FLAMMABILITY:
OTHER:
HMIS HAZARD CLASSIFICATION
HEALTH:
0
FLAMMABILITY:
PROTECTION:
0
0
REACTIVITY:
0
REACTIVITY:
0
EXTINGUISHING MEDIA: non flammable
SPECIAL FIRE FIGHTING PROCEDURES: none
UNUSUAL FIRE AND EXPLOSION HAZARDS: none
HAZARDOUS DECOMPOSITION PRODUCTS: none known beyond smoke hazard
SECTION 5 NOTES:
SECTION 6: ACCIDENTAL RELEASE MEASURES
PAGE 2 OF 6
MATERIAL SAFETY DATA SHEET
FILE NO.:
MSDS DATE: 06 /28 / 10
E2e Soy Based Resin System
ACCIDENTAL RELEASE MEASURES: No special requirements. Water clean up and rinse. Caution, will slippery surfaces.
SECTION 6 NOTES:
SECTION 7: HANDLING AND STORAGE
HANDLING AND STORAGE: Store refrigerated, below 45 F
OTHER PRECAUTIONS: none
SECTION 7 NOTES:
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
ENGINEERING CONTROLS:
VENTILATION : none required
RESPIRATORY PROTECTION: none required
EYE PROTECTION: wear safety glasses
SKIN PROTECTION: wear appropriate gloves to prevent skin exposure
OTHER PROTECTIVE CLOTHING OR EQUIPMENT: Lab coats are recommended
WORK HYGIENIC PRACTICES: Clean up spills quickly to avoid eliminate slippery conditions
EXPOSURE GUIDELINES: Not considered hazardous
SECTION 8 NOTES:
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE: Thick light brown protein suspension in water
ODOR: Odorless when fresh
PHYSICAL STATE: Liquid
pH AS SUPPLIED: 7 to 10
pH (Other):
BOILING POINT: 100 C
F:
C:
MELTING POINT: 0 C
F:
C:
FREEZING POINT: 0 C
F:
C:
VAPOR PRESSURE (mmHg): not tested
@
F:
C:
VAPOR DENSITY (AIR = 1): not tested
@
PAGE 3 OF 6
MATERIAL SAFETY DATA SHEET
FILE NO.:
MSDS DATE: 06 /28 / 10
E2e Soy Based Resin System
F:
C:
SPECIFIC GRAVITY (H2O = 1): not tested
@
F:
C:
EVAPORATION RATE: not tested
BASIS (=1):
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES (con’t)
SOLUBILITY IN WATER: This material is primarily water, so miscible with water
PERCENT SOLIDS BY WEIGHT: 10 to 15 %
PERCENT VOLATILE: About 90 % water by volume. No other volatile components
BY WT/ BY VOL @
F:
C:
VOLATILE ORGANIC COMPOUNDS (VOC):
WITH WATER:
WITHOUT WATER:
MOLECULAR WEIGHT:
VISCOSITY: not tested
@
F:
C:
0
LBS/GAL
LBS/GAL
complex mixture of proteins, polysaccharides and water
SECTION 9 NOTES:
SECTION 10: STABILITY AND REACTIVITY
STABLE
STABILITY:
UNSTABLE
Stable, nonreactive product
CONDITIONS TO AVOID (STABILITY):
INCOMPATIBILITY (MATERIAL TO AVOID): none known
HAZARDOUS DECOMPOSITION OR BY-PRODUCTS: none known
HAZARDOUS POLYMERIZATION: none known
CONDITIONS TO AVOID (POLYMERIZATION):
SECTION 10 NOTES: Stable, non reactive product
SECTION 11: TOXICOLOGICAL INFORMATION
TOXICOLOGICAL INFORMATION: No acute or chronic toxic effects expected
SECTION 11 NOTES:
SECTION 12: ECOLOGICAL INFORMATION
PAGE 4 OF 6
MATERIAL SAFETY DATA SHEET
FILE NO.:
MSDS DATE: 06 /28 / 10
E2e Soy Based Resin System
ECOLOGICAL INFORMATION: No special ecological considerations. Not considered environmentally harmful. Small quantities
may be drained to the sewer.
SECTION 12 NOTES:
SECTION 13: DISPOSAL CONSIDERATIONS
WASTE DISPOSAL METHOD: Small quantities may be drained to the sewer. For large quantities contact the local wastewater office
for procedures.
RCRA HAZARD CLASS: Not classified as hazardous
SECTION 13: DISPOSAL CONSIDERATIONS (con’t)
SECTION 13 NOTES:
SECTION 14: TRANSPORT INFORMATION
U.S. DEPARTMENT OF TRANSPORTATION
PROPER SHIPPING NAME:
HAZARD CLASS:
ID NUMBER:
PACKING GROUP:
LABEL STATEMENT:
Not classified as hazardous
WATER TRANSPORTATION
PROPER SHIPPING NAME:
HAZARD CLASS:
ID NUMBER:
PACKING GROUP:
LABEL STATEMENTS:
AIR TRANSPORTATION
PROPER SHIPPING NAME:
HAZARD CLASS:
ID NUMBER:
PACKING GROUP:
LABEL STATEMENTS:
OTHER AGENCIES:
SECTION 14 NOTES:
SECTION 15: REGULATORY INFORMATION
U.S. FEDERAL REGULATIONS
TSCA (TOXIC SUBSTANCE CONTROL ACT):
Not classified as hazardous
CERCLA (COMPREHENSIVE RESPONSE COMPENSATION, AND LIABILITY ACT):
SARA TITLE III (SUPERFUND AMENDMENTS AND REAUTHORIZATION ACT):
311/312 HAZARD CATEGORIES:
313 REPORTABLE INGREDIENTS:
STATE REGULATIONS:
PAGE 5 OF 6
MATERIAL SAFETY DATA SHEET
FILE NO.:
MSDS DATE: 06 /28 / 10
E2e Soy Based Resin System
INTERNATIONAL REGULATIONS:
SECTION 15 NOTES:
SECTION 16: OTHER INFORMATION
OTHER INFORMATION:
PREPARATION INFORMATION: MSDS prepared 6/28/10
DISCLAIMER:The information above is believed to be accurate and represents the best information currently available to us.
However, we make no warranty of merchantability or any other warranty, express or implied, with respect to such information, and
we assume no liability resulting from its use. Users should make their own investigations to determine the suitability of the
information for their particular purposes. In no event shall e2e Materials be liable for any claims, losses or damages of any third
party or for lost profits or any special, indirect, incidental, consequential or exemplary damages, howsoever arising, even if e2e
Materials has been advised of the possibility of such damages.
PAGE 6 OF 6