IDDRG 2016 Conference June 12-15, 2016 Linz, Austria INSTRUCTIONS AND TEMPLATE FOR SUBMISSION OF ABSTRACTS TO THE IDDRG 2016 CONFERENCE IN LINZ, AUSTRIA A. Author, B. Coauthor and C. Coauthor Advanced Steel Processing and Products Research Center Colorado School of Mines 920 15th St, Golden, CO 80401 USA e-mail: xx.yy@mines.edu, Web page: www.mines.edu/research/aspprc/ Automotive Division American Iron and Steel Institute 2000 Town Center, Suite 320, Southfield, MI 48075 USA e-mail: aa.zz@steel.org, Web page: www.steel.org ABSTRACT This document provides information on and instructions for preparation of an abstract for the IDDRG 2016 conference. The instructions in this document are written in the expected format and this document can be used as a template for the abstract. Please read and follow the instructions carefully. The abstracts must be written in English, no longer than 1800 letters and must not contain figures or tables. The abstract should contain a concise summary of the investigation, the results, and the conclusions. Microsoft Word must be used as the word processor. All of the instructions can be found and downloaded from the official website of the IDDRG 2016 conference (www.iddrg2016.org). Styles in Microsoft Word have been used to allow for easy formatting of each section of the abstract. Please use “A4" paper size (210 x 297 mm) (8.267 x 11.692 inches) and select 25 mm (0.984 inch) as top, bottom, left and right margins. The abstract must contain the IDDRG2016 header, Title, Author(s), Affiliation(s), Abstract, Keywords. Please use Times New Roman font. For the font sizes, please check the font sizes used in this page. For example, the title of the paper should be written centered, in 14pt, bold Times New Roman, all capital letters. It should be centered and single spaced if the title is more than one line long. Please see the layout shown on this page. The complete abstract with figure or table must be uploaded onto the Conference website as a single submission in doc format. If you have any problems or difficulties please contact the organizers via email (iddrg2016@asmet.at). Keywords: Forming: Die; Wear; Tribology; Simulation. (Please list up to eight key words, separated by semicolons)