MATERIAL SAFETY DATA SHEET Sante Manufacturing Inc. 2773 Thamesgate Dr. Mississauga, Ontario L4T 1G5 (715)804-4159 (800) 424-9300 - Chemtrec May be used to comply with OSHA's Hazard Communication Standard 29CFR 1910.1200. Standard must be consulted for specific requirements. SECTION I IDENTIFICATION Trade Name: Product Code: U.S. D.O.T. Shipping Name: Technical Name: U.S. D.O.T. Primary Hazard Class: U.S. D.O.T. Secondary Hazard Class: Identification Number: IATA (Airline) Maritime Packing Group: Spa Cream Soap SM - HO009 Non Regulated Not Applicable Non Regulated Not Applicable Not Applicable Non Regulated Non Regulated Not Applicable SECTION II HAZARDOUS INGREDIENTS--IDENTITY INFORMATION Components are considered to be non-hazardous as per OSHA 29 CFR 1910.1200. SECTION III Typical PHYSICAL & CHEMICAL CHARACTERISTICS Boiling Point: >100ºC Flash Point: No Flash ASTM D-56 Tag Closed Cup Vapor Density (Air=1): Greater than 1 Evaporation Rate (BA=1): Slower than Butyl Acetate Solubility in Water: Complete pH: 5.5 – 7.5 Appearance & Odor: Light cream colored pearl with floral fragrance Viscosity: 1100 – 1700 cps Note: Not all these tests are conducted routinely; it is recommended that you conduct your own. SECTION IV FIRE & EXPLOSION HAZARD DATA Extinguishing Media: Special Fire Fighting Procedures: Unusual Fire & Explosion Hazards: Not combustible. Always use Self Contained Breathing Apparatus. None known. SECTION V REACTIVITY DATA Stability: Conditions to Avoid: Hazardous Decomposition Products: Hazardous Polymerization: Stable. Strong oxidizers, acids, and caustics. None known. Will not occur. 106729965 1 SECTION VI SIGNS AND SYMPTOMS OF EXPOSURE: Eyes: Dermal: Inhalation: Ingestion: EMERGENCY AND FIRST AID PROCEDURES: Eyes: Dermal: Inhalation: Ingestion: HEALTH HAZARD DATA Causes eye irritation on direct contact. May cause skin irritation on prolonged or repeated contact. None known. May be harmful if swallowed in large quantites. Acute Health Hazards: Chronic Health Hazards: Flush with large amounts of water for 15 minutes. Flush with large amounts of water for 15 minutes. Not applicable Drink 1-2 glasses of water. Get medical attention. Do not give anything by mouth to unconscious person. Irritation of eyes. None expected on industrial level. SECTION VII SPILL OR LEAK PROCEDURES STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Absorb free liquid with earth, sand, clay, or absorbent pads. Wash area down with water. Rinse thoroughly. Can be slippery. WASTE DISPOSAL METHOD: In accordance with State and Local laws. SECTION VIII SPECIAL PROTECTION INFORMATION Respiratory Protection: Ventilation: Protective Gloves: Eye Protection: Other: Hygienic Practices: None required. Adequate to meet established minimums. Vinyl or rubber. Safety glasses. As needed. Always wash face and hands before eating. SECTION IX NOTES The information contained herein is based on data considered accurate. However, no warranty is expressed or implied regarding the accuracy of this data or the results to be obtained from the use thereof. Vendor assumes no responsibility for injury to vendee or third person proximately caused by the material if reasonable safety procedures are not adhered to as stipulated in the data sheet. Additionally, vendor assumes no responsibility for injury to vendee or third persons proximately caused by abnormal use of the material even if reasonable safety procedures are followed. Furthermore, vendee assumes the risk in the use of this material. Revised date: 106729965 Thursday, May 05, 2011 2