MATERIAL SAFETY DATA SHEET Page 1 From: C A R K E M P R O D U C T S, I N C. 4275 St. Johns Parkway Sanford, FL 32771 (800) 423-3168 Emergency phone #: (800) 424-9300 CHEMTREC To comply with OSHA form #174 SECTION 1 – IDENTIFICATION OF PRODUCT Product Name: Product Code: Synonym or Cross Reference: NYLON SPOTTER NS XYLENE SECTION II – HAZARDOUS INGREDIENTS Ingredients: Xylene CAS No. 1330-20-7 TLV WGT % SECTION III – PHYSICAL DATA Appearance: Odor: Specific Gravity Vapor Pressure (mmHg): Boiling Point: Melting Point: Clear Liquid Aromatic Odor 0.86 21 @ 100 F 281 F N/A Vapor Density; 3.7 (Air = 1) Evaporation Rate: 0.6 (Ethyl Ether =1) Solubility In Water:Negligible PH: N/A SECTION IV – FIRE AND EXPLOSION DATA Flash Point: Lower Flammable Limit %: Upper Flammable Limit %: Fire Extinguishing Media: Special Fire Fighting Procedures: Unusual Fire and Explosion Hazard: 79 F (TCC) 1 7 Carbon Dioxide, Dry Chemical, Foam. Wear appropriate protective equipment as conditions warrant. Cool fire exposed or fire threatened containers. Vapors are heavier than air and may flashback SECTION V – HEALTH HAZARD / TOXICOLOGICAL PROPERTIES Acute Effects Eyes: Skin: Contact with eyes can cause irritation, redness, tearing, blurred vision, and/or swelling . Contact with skin can cause irritation, (minor itching, burning and/or redness), dermatitis, defatting may be readily absorbed through the skin. Inhalation: Inhalation of vapors can cause nasal and respiratory irritation, dizziness, weakness, fatigue, nausea, headache, possible unconsciousness and/or asphyxiation. Aspiration of material into lungs may result in chemical pneumonitis, which can be fatal. May be toxic. Ingestion:Ingestion can cause gastrointestinal irritation, nausea, vomiting, diarrhea. Chronic Effects: Unknown Carcinogenic: Yes _ No _X Teratogen: Yes _ No _X Mutagen: Yes _ No _X Primary Routes of Exposure: Inhalation, Skin, Ingestion. F I R ST AID Inhalation: Skin: Eyes: Ingestion: If inhaled, remove victim from exposure to well ventilated area. Make him/her comfortably warm, but not hot. Use oxygen or artificial respiration as required. Consult a physician. Flush with water immediately and then wash off with soap. Remove contaminated clothing. For eye contact, flush promptly with excess water for at least fifteen minutes. Consult a physician . If ingested, do not induce vomiting. Call a physician immediately. MATERIAL SAFETY DATA SHEET Page 2 From: C A R K E M P R O D U C T S, I N C. 4275 St. Johns Parkway Sanford, FL 32771 (800) 423-3168 Emergency phone #: (800) 424-9300 CHEMTREC Product Name: NS- NYLON SPOTTER SECTION VI – REACTIVITY DATA Stability: Conditions To Avoid: Incompatibility Materials To Avoid: Hazardous Decomposition Products: Hazardous Polymerization: Stable Keep away from heat sources, sparks and open flame. Strong oxidizers Carbon monoxide Will not occur. SECTION VII – SPILL AND DISPOSAL PROCEDURE Spills, Leak or Release: Waste Disposal: Wipe up carefully FLAMMABLE Dispose of in accordance with Local, State, and Federal Regulations. SECTION VIII – PROTECTION INFORMATION Respiratory Protection: Ventilation: Protection Gloves: Eye Protection: Other Protective Equip. Eyewash Approved organic cartridge respirator should be available, with self contained breathing apparatus. Explosion – proof equipment, normal local exhaust. To prevent prolonged exposure, use rubber gloves. Impervious type. Safety glasses or goggles with splash guard or side shields. Wear protective clothing as required to prevent skin contact. Station should be available. SECTION IX – HANDLING AND STORAGE PRECAUTIONS Storage and Handling: Store in well ventilated area, and avoid open fire or flame. Avoid breathing vapors. Keep away from children. SECTION X – ADDITIONAL INFORMATION Shipping Information: Please comply with DOT regulations in USA Hazard Rating: 0 = Insignificant Health 2 1 = Slight Fire 4 2 = Moderate Reactivity 0 3 = High Personal Protection – see section VIII 4 = Extreme Product Code: NS Prepared on: 08/2003 This information in the Material Safety Data Sheet has been compiled from our experience and date presented in various technical publications. It is the user’s responsibility to determine the suitability of this information for the adoption of the safety precautions s may be necessary. We reserve the right to revise Material Safety Data Sheets from time to time as new technical information becomes available. The user has the responsibility to contact the company to make sure that the sheet is the latest issue.