MATERIAL SAFETY DATA SHEET SERIAL NO: PRODUCT NAME: Acrylic Clear coat PRODUCT USE: Acrylic Clear Coat ISSUE DATE: Friday, 12 February 2016 REF NO: 0772 FORMULA NO: 200772 SECTION 1: AZARDOUS INGREDIENT INFORMATION Chemical identity Conc. CAS No. PIN No. Toluene 40-60 SECTION 11: REPARATION INFORMATION Prepared by : SUBRAMANIAM MASILAMANY Telephone : 416-286-3336 Date of preparation : Friday, 12 February 2016 SECTION 111: RODUCT INFORMATION Product identifier : Acrylic Clear Coat Manufacturers Name : TIDOL CORPORATION Street Address : 1275 MORNINGSIDE AVENUE City : SCARBOROUGH Province : ONTARIO Country : CANADA Postal Code : M1B 3W1 Emergency Tel. : 416-286-3336 Product's Use : To Paint metal surfaces Supplier Information Suppliers Name : Street Address : City : Province : Postal Code : Emergency Tel. : Product's Use : 1 SECTION 1V: PHYSICAL DATA Physical State Odour and Appearance Odour Threshold Specific Gravity Coefficient of water/ oil distribution Vapour Pressure Boiling Point Freezing Point pH Vapour Density Evaporation Rate Percent volatile by Volume : Liquid : Solvent and colourless : Characteristic of toluene : 0.90 approximately : Infinity : not applicable : 60 C : -25 C or below : Not applicable : Not applicable : Not applicable : 99% SECTION V: FIRE AND EXPLOSION HAZARD Condition of Flammability : Open fire, Excess heat Means of Extinction : Water, foam or carbon dioxide Explosion Data Sensitivity to Mechanical Impact : Not applicable Sensitivity to Static Discharge : Not applicable Flash Point and Method : 35C Cleveland open cup Upper Flammable Limit % : Not available Lower Flammable Limit % : Not available Auto ignition Temperature : Not available Hazardous Combustion Products : None SECTION V1: REACTIVITY DATA Stability Incompatible Materials Conditions of Reactivity Hazardous Decomposition Products : Stable under normal temperature : Other chemicals : None known to the manufacturer : None known to the manufacturer SECTION V11: TOXICOLOGICAL PROPERTIES LD50 Species and Route : Not Available LC50 Species and Route : Not Available Route of Entry : Skin contact -Yes Skin Absorption-Yes Eye Contact -Yes Inhalation -Yes Ingestion -Yes Effects of Acute Exposure to Product : Not applicable. Exposure Limits : Not applicable. Irritancy to Product : Moderate to eyes. Synergistic Products : Not known to the manufacturer. 2 SECTION V111: PREVENTIVE MEASURES Personal Protective Equipment : Not applicable Gloves (specify) : Not necessary, but recommended. Respiratory (Specify) : Not required Eye (Specify) : Not necessary. Footwear (specify) : Not necessary. Other Equipment (Specify) : Consult your supervisor Engineering Controls (Specify) : Natural ventilation sufficient. Leak and Spill Procedures : Absorb with sand and oil dry Waste Disposal : Observe all Local, Provincial and Federal regulations. Handling Procedures and Equipment : Follow normal procedures. Storage Requirements : Store away from food Special Shipping Information : Flammable liquid N.O.S UN 1263 Class 3.2 Pkg Group 11 SECTION 1X: FIRST AID MEASURES. Inhalation : Move to fresh air Ingestion : Do not induce vomiting, give milk and seek medical advice. Eye contact: Flush with water and see doctor Skin Contact : Flush with water and see doctor. ADDITIONAL INFORMATION: Detergents are products made by blending different chemicals possessing different degrees of different hazards. It is difficult to determine the combined effect of these chemicals. Therefore discretion on the part of the Supervisor and operators are kindly requested. Sources Used : Merck's Index, TDG Act, WHMIS etc NON WARRANTY: Prior testing for fitness for use by the purchaser and purchaser's compliance with applicable statues is a strict condition of sale. The information given above are prepared from our knowledge of the product. All recommendations and suggestions are believed reliable but should not be construed as warranties. Tidol Corporation disclaims any liability incurred in connection with the use of the product or the data given above. 3