FDOT Matrix Derived from Specification 660 (FA 2-13-13) Rev 1.0
FDOT Traffic Engineering Research Laboratory (TERL)
Inductive Loop Detection System Compliance Matrix
Date:
Click here to enter a date.
Manufacturer:
Applicant’s
Name (print):
Item, Model No.:
Signature:
ID
No
Section
Requirement
The following compliance matrix criteria are for all inductive loop detection systems
1
660-2.1.2.1
Inductive loop detection system uses a minimum of one inductive
loop and loop detector.
2
Detection system operates by energizing and monitoring wire
embedded in the road surface to detect vehicle presence and
provide an output to traffic controllers or other devices that can
generate volume, occupancy, and speed data (detection output).
3
660-2.1.2.1.1
Item
Comply?
(Yes/No)
By signing this form, the applicant declares that he/she has read and
understands the provisions of Section 660 of the FDOT Standard
Specifications for Road and Bridge Construction and all implemented
modifications. The requirements listed on this matrix are derived from Section
660, and are the basis for determining a product’s compliance and its
acceptability for use on Florida’s roads.
Comments
(Applicant must provide information as indicated)
Applicant may provide comments in this field.
If rack-mount, inductive loop detector unit meets the
requirements of NEMA TS-2-2003; if shelf-mount, detector unit
meets the requirements of NEMA TS-1-1989.
Detector meets the requirements for modes of operation in
NEMA TS2-2003, 6.5.2.17.
Document Review and
Functional Inspection
Provide product literature, specifications, user manual,
or similar information that shows the product meets this
requirement.
Indicate location of requested information in submittal.
Document Review and
Functional Inspection
Provide product literature, specifications, user manual,
or similar information that shows the product meets this
requirement.
Indicate location of requested information in submittal.
The following compliance matrix criteria are for inductive loop detection systems to be used as traffic data detectors
6
660-2.3
Vehicle detection meets the minimum total roadway segment
Provide product literature, specifications, user manual,
accuracy levels of 95 % for volume, 90% for occupancy, and
or similar information that shows the product meets this
90% for speed for all lanes, up to the maximum number of lanes
requirement.
that the device can monitor as specified by the manufacturer
Indicate location of requested information in submittal.
when calculated in accordance with all criteria as detailed in 6602.3.1 and all subsections therein.
The following compliance matrix criteria are for all inductive loop detection systems
7
660-2.5
Detector meets the environmental requirements of NEMA TS-2Provide a third party test report that demonstrates
2003.
compliance with this requirement. The test report must
meet the requirements of FDOT PCH, section 7.2.
Indicate location of requested information in submittal.
Page 1 of 1
Functional Inspection
Provide product literature, specifications, user manual,
or similar information that shows the product meets this
requirement.
Indicate location of requested information in submittal.
The following compliance matrix criteria are for inductive loop detection systems to be used as presence detectors
4
660-2.2
Detector provides a minimum detection accuracy of 98% when
Provide product literature, specifications, user manual,
calculated in accordance with all criteria detailed in 660-2.2.1
or similar information that shows the product meets this
and all subsections therein.
requirement.
Indicate location of requested information in submittal.
5
TERL Evaluation
Method
Document Review and
Functional Inspection
Document Review and
Functional Inspection
Document Review and
Functional Inspection
Document Review