Ultima 360 Protection Kit
Instruction Guide
Introduction
With Ultima's complete Wipe-on, Walk Away system, you can protect your entire car for months in less than an hour.
No other system lasts as long or is as easy to apply. We guarantee it!
The Ultima 360 Protection Kit covers every surface of your car with the latest in nanotechnology polymers (patent
pending) that are virtually impervious to soil, pollution, insects, sap, tar, oil, and detergents. Ultima protection is
created by clear molecules that are so small that dirt, pollution and cleaner can't break through.
Ultima Paint Guard Plus Instructions
Ultima Paint Guard Plus, containing Polycharger™ Wax Booster technology, is the longest lasting, clearest and easiest
paint protection solution. This product takes less than ten minutes to apply to a clean, dry vehicle. Simply spray on and
walk away. No buffing required. Ultima Paint Guard Plus is a highly concentrated paint sealant. A single ounce is enough
sealant to treat and seal 8 to 10 vehicles, including the glass.
1. Work on a completely clean and dry vehicle for best results.
2. Mist the included Ultima Microfiber Applicator with Ultima Paint Guard Plus twice (two pumps) to prime the pad
with sealant. Use sparingly, about ¼ ounce is all that’s needed to treat most cars.
3. Start at one corner of the vehicle. Wipe the sealant in well and finish by wiping in a straight line. This will help to
see where product has been applied. When it appears that no more sealant is being applied to the paint, spray
one more shot of sealant onto the applicator.
4. Continue to wipe until the entire vehicle is complete. By the time you get back to where you began, the first
couple of panels should already look dry.
Proper Application Note: When applying, sealant should not go on looking "wet". Proper application leaves what
appears to be an oily film which will begin to dry immediately. Do Not Buff Off or Wipe! When properly applied, the
vehicle's paint finish will be glossy and streak-free in less than 30 minutes. The longer you wait (up to 12 hours) the
better. After 1 hour, you can drive your vehicle. Driving (air friction) will accelerate the cure time.
Frequency of Use: While Ultima Paint Guard Plus has been tested for durability (shine, water beading and slickness) up
to a year, proper paint care dictates that 3-4 treatments a year offers the very best protection possible.
More Shine: Ultima Paint Guard Plus can be layered to produce more shine. In most cases, 2-3 coats of Ultima Paint
Guard Plus can produce stunning results. To keep this shine, re-treat monthly and maintain with Ultima Detail Spray.
Ultima Interior Guard Plus Instructions
Ultima Interior Guard Plus uses superior science and technology to coat, seal and protect every finish in your fine
vehicle. This clear sealant dries completely and will not leave a greasy, slippery film that attracts dust. Instead, fabric,
leather and vinyl all take on the tactile feel of fine cashmere. You will glide in and out of your leather seating and feel a
new comfort that is silky smooth, but not slippery.
1. Work in a completely clean and dry interior for best results. If stains are present, treat with an appropriate stain
remover before sealing. Just as Ultima Interior Guard Plus prevents stains from setting, it will also seal in stains.
2. Mist the soft side of the included Ultima Dual-Foam Interior Applicator with Ultima Interior Guard Plus very
sparingly. Two pumps is all that’s needed.
3. Wipe Ultima Interior Guard Plus in well.
4. Finish by wiping in a straight line so you can see where the product has been applied.
5. When it appears that no more product is being applied to the finish, spray one more shot of product onto the
applicator. Do not spray directly on to the interior finishes (except fabric and carpet).
6. Continue to wipe until the entire interior is complete.
7. Allow the doors and windows to remain open for at least 30 minutes after application to aid in drying.
8. After 1 hour, you can sit in your vehicle.
For Fabric and Carpet:
1. Before treating, fabric and carpet must be clean and completely dry. Do not treat a damp surface, as the sealant
will not properly bond with the textile.
2. To apply, mist over an area of fabric or carpet and towel-in using a microfiber detailing towel. Do not saturate
the fabric. Two light coatings are more effective than a heavy coating.
3. Allow one to two hours of drying time between coatings. Ventilate the vehicle while applying and drying.
4. After 1 hour, you can sit in your vehicle.
Ultima Tire & Trim Guard Plus Instructions
Ultima Tire & Trim Guard Plus is a new polymer coating that can be applied to most flexible surfaces (vinyl and rubber)
and hard surfaces (plastic and metal) to coat, seal, protect and beautify. No ordinary “dressing” lasts as long or protects
as well against pollution, ultra violet light (sun), road salts, harmful ozone, creosote and more.
1. For best results, be sure that tires and trim are clean and completely dry.
2. While Ultima Tire & Trim Guard Plus may be applied in the sun, we recommend application in a shaded area
3. For all plastic and rubber trim, mist the soft side of the Ultima Dual-Foam Applicator with Ultima Tire & Trim
Guard Plus. For all hard surfaces, including wheels, chrome trim, stainless steel trim, and exhaust tips, use the
firm side of the applicator. Use Sparingly: About ¼ ounce is all that is needed to treat four tires and wheels
4. Wipe the product in well on the surface to be treated.
5. Proper application should leave a rich-looking, dark film. As the film dries it will take on the natural sheen of the
surface.
6. After application do not buff off or wipe, just sit back and watch as Ultima Tire and Trim Guard plus does its job.
The vehicles trim will look as it did when new.
Frequency of Use: Ultima Tire & Trim Guard Plus is the most durable treatment available for trim. While we have tested
for visible protection up to a full year, proper trim care dictates that 4 treatments a year offers the very best protection
possible. Tires may require treatment monthly to maintain a crisp, freshly detailed appearance; however a single
application will maintain protection for three full months. To maintain your trim, all you need to do is wash and dry your
vehicle regularly.
More Tire Shine: Ultima Tire & Trim Guard Plus can be layered to produce a jaw-dropping, show car tire shine that will
turn heads. In most cases, on a perfectly clean and dry tire, 2-3 coats of Ultima Tire & Trim Guard Plus produces
stunning results. Be sure to allow product to dry to the touch prior to applying additional coats.