49-01 Which of the following is a purpose of the Ammunition and Hazardous Materials Handling Review Board? (AMHAZ) A: Look over any proposed site plans 49-02 which deviation is CNO approved to satisfy a long-term, non-recurring readiness or operation requirement? A: Exemption 49-03 As a minimum, where are the applicable portions of required to be present? A: Work area where the operation is performed 49-04 Which of the following is a requirement for an SOP? A: Communicate the known hazards of an operation 49-05 Which material is capable of such rapid decomposition that tremendous energy is released virtually instantaneously? A: Explosive 49-06 Which term is defined as "the ease with which an explosive can be initiated by impact heat or friction"? A: Sensitivity 49-07 What are individual pieces of propellant called? A: Grains 49-08 Which application of pyrotechnics is used in the military? A: Battlefield simulation 49-09 Your facility received a shipment of ordnance items that are Compatibility Group E. Knowing that your facility does not have permission to use "Z" storage, in which of the following magazines could you store the shipment of Compatibility Group E ordnance? A: Magazine 4 contains items in Compatibility Group S 49-10 What would be the minimum number of magazines needed to store NALC/DODICs A577, A919, D544, and G890(Click each highlighted NALC to view its data sheet and click on the View References button to view the Storage Compatibility table.) A: 3 49-11 Which fire symbol would be posted on a magazine containing ordnance from the NALC/DODIC entry below? A: Fire symbol 1 49-12 Which hazard symbol is required for magazine filled with NALC/DODIC entry G905? A: Full Protective Clothing Set 1 49-13 Which fire symbol signifies ammunition with a mass explosion hazard? A: Fire Symbol 1 49-14 Using the Transportation Compatibility Table; determine which footnote would allow the two NALC/DODIC entries to be transported together on the same vehicle. (Click the View References button to see the Transportation Compatibility Table.) A: Footnote 6 49-15 Personnel would be allowed to ride in the cargo compartment of the vehicle transporting ordnance during the transportation ordnance during the transportation of: A: 1.4S small arms ammunition material 49-16 Which of the following inspection points would make a vehicle unsuitable to haul ordnance? A: Uncharged fire extinguisher 49-17 The purpose of QD requirements is to... A: Limit the damage from an accidental explosion to acceptable levels 49-18 Which level of protection is intended to protect people in vehicles on a nearby highway from serious injury and death due to effects of an accidental explosion? A: PTR 49-19 Currently you storage magazine has a total of 90,000 lbs of HC/D 1.1 ordnance and nothing else inside the magazine? (See the placard in the image for NEWs.) A: 10,000lbs 49-20 Using the DISTANCE IN FEET TO INHABITED BUILDIG FROM table, determine how much NEW can be stored in an ECM that has a front orientation and is located 2,000 feet from an IBD. (Click the highlighted text above to view the table.) A: 135,000 lbs 49-21 Using the APPLICAITON OF INTERMAGAZINE DISTANCE table and the INTERMAGAZINE HAZARD FACTOR AND DISTANCE table, determine how many pounds of NEW can be stored in an unbarricaded AGM (PES) facing the side of a 3-Bar ECM (ES), which are 280 feet apart from each other. (Click the highlighted text above to view the tables.) A: 100,000 lbs 49-22 What color flag should be displayed to signify that work involving ammunition and explosives is in progress? A: Red 49-23 Which type of powered forklift can be used to handle packaged ordnance in a shore side ECM? (Click the View References button to see Table 5-2 Approved MHE Ashore Packaged). A: EX 49-24 What system is used by the Navy and Marine Corps for recording and reporting mishaps? A: WESS 49-25 What LPS consist of air terminals that are mounted directly on the structure to be protected? A: Integral system