Year 11 Integrated Technologies Term 3 Weekly Focus Week 1 Battery Construction Week 2 Battery connections Week 3 Battery resistance. Unit Test. Week 4 Capacitors Week 5 Identify capacitors. Series and Parallel connections of Capacitors. Week 6 Series and Parallel connections of Capacitors. Week 7 Unit test Capacitors Start model Week 8 Construction of Line tracking model Week 9 Testing line tracking robot. Learning and Assessment Homework Compare primary cells with secondary cells (wet) in terms of size, voltage, capacity and cost. State procedures and precautions for handling and charging secondary cells/batteries. Complete work sheet notes section 8.1 – 8.2 batteries. Complete chapter notes Correctly connect cells to form a battery of specified voltage and current rating. Calculate and measure the terminal voltage for both series and parallel connected batteries. Complete work sheet notes section 8.3 – 8.4 batteries. Create a list of hazards when dealing with batteries. Describe the effect of internal resistance on the terminal voltage of a battery under load. Include the effect of temperature on internal resistance. . Complete work sheet notes section 8.3 – 8.4 batteries. Revision of battery unit. Unit test Batteries. Revise unit topics for battery unit test. Describe the construction of a capacitor. Define the parameters used to size a capacitor. Understand the method of charging a capacitor purpose and uses. Read and complete questions on handout sheet. Identify the different types of capacitors use and be able to work out the various sizes of capacitors. Calculate the sizes of the capacitors and connections of series and parallel circuits. Complete all Questions Calculate the circuit value of capacitance when the circuits are connected in series. Complete various calculations. Calculate the value of capacitance when the circuits are connected in parallel. Complete the question sheets with circuits showing the connections. Calculate all circuits correctly. Complete work sheet. Revision of capacitor unit. Students to start Practical unit Robot design line Tracking mouse. Identify components in model. Revise capacitor topics for unit test. Assemble gear boxes to robot. Start to solder components to circuit board. Attach all equipment and check for operation. Complete evaluation stage 1. Complete work sheet. Connect and check all sensors for operation on line tracking mouse. Connect and operate system check for faults or operation problems, Complete evaluation sheet stage 2. Complete work sheet. Complete all Questions Week 10 Unit Test Model construction. Revision of electrical concepts and electrical topics. Assessment of topics unit test. Batteries and Capacitors. Completion of evaluation sheet stage 3. Completion of model for final assessment. Revision of topics.