Instruction Sheet
Thank you for purchasing this LaserForks unit, we appreciate your business.
To begin using this product you will need to get it ready for installation, before installing it onto
your forklift.
To get it ready, please do the following steps;
1. Remove unit from package (please recycle the 100% recyclable
packaging products)
2. The following parts should have come inside the package…
a. Main aluminum LaserForks unit
b. Box with battery charger inside including power cord for
110 volt AC
c. Instruction Sheet (what you are reading now)
3. Do not plug the battery connector in until later in the
instructions, so the laser does not come on with movement, so
the beam does not accidentally shine at you or anyone else.
YOU ARE NOW READY TO MOUNT THE UNIT….
4. Using a tape measure, measure the length of the back base
plate where the LaserForks unit will be mounting. Make sure
you measure from the bottom edge to the top span
requirement (to where brackets can make contact)
5. Using a tape measure and wrench, adjust the slider bar up or
down to lengthen as needed to fit on back base plate
6. Mount the adjusted LaserForks unit onto your base plate by
putting on its side first, for checking location position

NOTE: The laser on the bottom of the LaserForks unit
should be approximately halfway centered on the
thickness of the tine/fork blade (about 2 inches below
the bottom base plate (see picture) The unit is
movable/repositionable after mounting it, and you will
probably have to move it a little to align laser with
actual thickness of fork/tine.
 Go ahead and peel back the black Velcro strip on top of
the laser housing, and plug the battery connect
together, this will turn on the laser and when the
LaserForks unit is moved it will turn itself on.
7. To align laser to tips, move the LaserForks unit up or down to
correctly position the laser fan shaped beam, so it is straight
horizontally and as shown in the picture
8. If the laser beam is angling up or down and is not horizontal,
you can make adjustments by loosening the screws to the
laser housing block and change the angle of the laser beam to
make it horizontal/flat. If you move tilted downward, it angles
the laser more downward, and likewise if you tilt it more up
the laser tilts more upward.
TO CHARGE THE BATTERY …
a. You do not need to remove the LaserForks unit from the
forklift, simply open one side of the black Velcro cover on
the unit.
b. Disconnect the plug to the battery and remove the battery
from the unit, and reattach the Velcro cover. *(you can
still use your forklift, just not the LaserForks unit)
c. Connect the battery to the charger, and the charger will
need to plug into a 110 volt outlet. (* NOTE: please make
sure that the battery charger is set to the 3.7 volt switch
setting)
d. The charger light will be red while it is charging, once it
turns green or off, the battery is fully charged
Sometimes one of your forklift forks will be bent, and not align
with the other fork (the tip of one will be lower than the other
one) The best thing to do is to try to balance the laser beam
between them by turning the LaserForks unit at an angle to
accomplish this. (if you offset the laser the wrong way, the laser
beam will get even more crooked, just turn it the other way to
correct). Or you can just leave LaserForks unit straight and
balance up & down between the 2 forks/tines
** REMEMBER – this LaserForks unit needs movement to turn itself on, and it will stay on
unless 4 minutes of non-movement occurs, then the unit will turn itself off, until movement is
detected again. This will allow your battery to last as long as possible between charging.
LaserForks
“Made in the USA”