Geometric Calibration Verification DMC II 230 – 017 Geometric Camera Calibration Verification Certificate No: DMC II 230 – 017 For Richard Crouse & Associates 467 Aviation Way Frederick, MD 21701 USA Document1 Document Version 3.0 page 1 of 5 DMC II 230 Calibration Protocol Camera: DMC II 230 Manufacturer: Intergraph Z/I Deutschland GmbH, D-73431 Aalen, Germany Reference: PAN Serial Number: 00119895 (PAN Head) Date of Calibration: 22. February 2011 Date of Report: 20. October 2014 Number of Pages: Calibration performed at: Carl Zeiss Jena, Carl-Zeiss-Promenade 10, 07745 Jena, Germany. This camera system is certified by Z/I Imaging and is fully functional within its specifications and tolerances. Date of Calibration: February 2011 Date of Certification: October 2014 Jürgen Hefele, Senior Software Developer Dipl.Ing. Christian Müller, Technical Consultant Document1 Document Version 3.0 page 2 of 5 DMC II 230 Calibration Protocol Camera Serial Numbers and test flight Camera Head PAN (reference) MS1 (NIR) MS2 (Blue) MS3 (Red) MS4 (Green) Serial Number 00119895 Calib. Date 00118806 00118818 00118809 00118843 14.01.2011 14.01.2011 14.01.2011 17.01.2011 22.02.2011 Test flight performed: 05. May 2014 Test block configuration Document1 Document Version 3.0 page 3 of 5 DMC II 230 Calibration Protocol Photo Scale Flying Height [m] Flying Altitude [m] Run-Spacing [m] Base-Length [m] Number of Exposures Side-lap [%] End-lap [%] Terrain Height [m] 1:10717 955 AGL 1088 AMSL 577 340 78 40 60 133 Number of strips Photos in one strip 6 2 x 9 N-S 4 x 15 W-E 78 23 10 6 Photos Used Control Points Used Check Points Used GSD [cm] Document1 Document Version 3.0 page 4 of 5 DMC II 230 Calibration Protocol Aerial triangulation statistic results: Matching results: 0 Weak Areas – covered with clouds Whole Block 78 exposures used 0 exposures not used Whole Block Whole Block Sigma relative: 0.698 um Sigma absolute: 0.769 um The results of the aerial triangulation were generated with ImageStation Automatic Triangulation (ISAT) 2014, Version 14.00.0000.00533, from Intergraph Inc. The maximum RMS in check points is < 0.32 GSD in x, y and < 1.45 GSD in Z. With this certificate we confirm that DMC II 230-017 is within geometric accuracy. Aerial Triangulation performed by _____________________ Dipl. Ing. C. Müller Document1 Document Version 3.0 20.10.2014 Date page 5 of 5