1. objectives - Boise State University

advertisement
Boise State University
Department of Electrical and Computer Engineering
ECE 212L Circuit Analysis and Design Lab
Fall 2012
Lab Report #1
Experiment #1: Waveform Measurements
Date Performed: 09/10/12
Date Due:
09/17/12
Date Submitted: 09/17/12
Instructors: Prof. Bob Hay
Student:
Peter Parker
TABLE OF CONTENTS
1.
2.
OBJECTIVES ..................................................................................................................... 3
DATA ANALYSIS AND INTERPRETATION........................................................................ 3
2.1
Average and RMS Values of an Arbitrary Waveform.................................................... 3
2.2
Theoretical Values for Built-in and Arbitrary Waveforms .............................................. 3
2.3
Theoretical RMS Values of Built-In and Arbitrary Waveforms ...................................... 3
2.4
Comparison of Equipment Accuracy ............................................................................ 3
3. DISCUSSION ..................................................................................................................... 3
4. CONCLUSION .................................................................................................................... 3
APPENDIX: DATA SHEET......................................................................................................... 4
2
1. OBJECTIVES
Write the objectives of this lab in your own words. Do not plagiarize the lab handout.
2. DATA ANALYSIS AND INTERPRETATION
2.1 Average and RMS Values of an Arbitrary Waveform
(Answer 1)
Here is an example on how to use the Microsoft Equation Editor 3.0. You can also go to
http://www.mathtype.com and download a trial version of MathType which is an enhanced
version of the Microsoft Equation Editor 3.0:
x
 b  b 2  4ac
2a
(1)
2.2 Theoretical Values for Built-in and Arbitrary Waveforms
(Answer 2)
2.3 Theoretical RMS Values of Built-In and Arbitrary Waveforms
(Answer 3)
2.4 Comparison of Equipment Accuracy
(Answer 4)
3. DISCUSSION
In separate paragraphs, discuss problems encountered during the lab and explain any
discrepancies between measurements and theoretical (predicted) results. Discuss sources of
error.
4. CONCLUSION
In one paragraph, summarize the objectives accomplished by the experiment and give feedback
on how to improve the experiment.
APPENDIX: DATA SHEET
3
Download