MPSEDC
Topics
•
•
•
•
•
•
Introduction of MPSWAN
Structure of MPSWAN
POP locations details
Network Diagram
POP Equipment Details
IP Address Allocation
MPSEDC
Introduction to MPSWAN
• MPSWAN is Madhya Pradesh state wide area Network.
• MP SWAN will create a vertical connect(backbone):A)-SHQ = 1
B)-CHQ=10
C)-DHQ=39
D)-BHQ=292
• Horizontal- all department will connect.
• MPSWAN will carry data, voice and video traffic.
MPSEDC
Structure of MPSWAN
MPSEDC
Summery of POP Locations
Name of the MPSWAN
POP
No. of the vertical POPs
SHQ
1
1
152
CHQ
10
10
378
DHQ
39
39
594
BHQ
310
282
286
TOTAL
360
332
1410
MPSEDC
No. of the vertical
POPs Operational
No. of the Horizontal
connects operational
MPSWAN Network
•
As per the proposed Network Architecture of SWAN, POPs are
divided into four groups:
A).Tier-1 POP--NMC at Bhopal.: 01
B).Tier-2 POP -- all Divisional HQ: 10 (Excluding State HQ)
C).Tier-3 POP -- all District HQ: 39
D).Tier-4 POP -- at Block/Tehsil HQ: 310 .
•
Apart from this the proposed SWAN network will be divided into two
parts namely:A). SWAN Backbone
B).User Departments Connectivity
•
SWAN Backbone will be through conventional lease lines and all
MPSWAN backbone lease.
MPSEDC
MPSWAN Network diagram
MPSEDC
POP Equipments Details








DG
UPS
Router
Switch
Modems
IP Phone
PDU
SNMP
MPSEDC
1-Disel Generator
A). 8KVA capacity
B). Fuel consumption check (by dip level or by flow meter ).
C).Check fuel tank, battery status

2-UPS
A). Types of UPS :1-CHQ/DHQ = 6KVA UPS with 2hours backup.
2- BHQ= 3KVA UPS with 4-5 hours backup.
B).As above diagram please ensure all are connected.
C).Ensure that all batteries are connected.
D).for any UPS complaint :- log to Emerson
toll free no :email id.
MPSWAN Equipments Details
3-Router:
• Router is a device that connects two networks.
A).Router used in MPSWAN network:
• SHQ=Cisco 7609 series.
• DHQ\CHQ=Cisco 7206 series
• BHQ=Cisco 2821 series
• horizontal offices=Cisco 2801 & Cisco 1841 series
MPSEDC
Cisco 7206 Router
MPSEDC
MPSEDC
MPSEDC
Interface physical position
• In Cisco 7206 Six slots are available in Router
Front Side.
A)-STM Card install in Slot No. 1 and 3
B)-E1 Card install at Slot No. 4
C)-Slot No. 2,5,6 are Vacant for future use.
• In Cisco 7206 Back Side 4 Slots are available:A)-In slot 0(zero) three Gigabit interface
B)-one fastethernet interface are
available.
MPSEDC
Cisco 2821 Router
MPSEDC
Interface physical position
• In Cisco 2821 two Slots are available
A)-In slot zero, two gigabit interface/
B)- Two serial interface is install. Serial interface is used for
WAN connectivity.
c)-BRI interface
D)-In slot one, two G.703 port are available. One G.703 port
is used connectivity between DHQ to BHQ pop and one is
vacant for future use.
MPSEDC
4-Switch:• Switches are used to connect multiple devices on the same network
within a building or campus.
• The data link layer (layer 2) of the OSI model.
• Two types of Switch-
A)-Manageable Switch- The switch can be monitored and adjusted
locally or remotely to give you control over network traffic. For security
we create the VLANs this type of switch.
B)-Unmanageable Switch- does not allow you to make changes and
Home-networking equipment typically offers unmanaged switches.
• We are use the following Cisco switchesA)-NMC-CISCO-6509
B)-POP Room(All)-CISCO 2960
.
MPSEDC
Cisco 2960 switch
Cisco 2960 switch have 48 ports of Fast Ethernet connectivity
MPSEDC
5-Modems
•
A modem is a communication device that converts binary (digital)
signal into analog and analog to binary signals.
•
We use One/Two Pairs modem for connectivity-
•
How to Connect Modem in NetworkA)-Both end v.35
B)-Both end Ethernet
C)-Customer end V.35 and Exchange end G.703
A-Master modem-Install at BSNL or POP end.
B-Slave Modem- Install at Customer end.
MPSEDC
MPSEDC
6-IP Phone
•
•
IP phone is internet protocol phone.
full-feature telephone that provides voice
communication over the same data network.
• When IP phone is registered, phone displaying the
Unique no like 1009 or 1008.
MPSEDC
Cisco 7970 IP phone
MPSEDC
7-PDU(Power Distribution Unit
• PDU reboot abilities for network access to remote sites and data
center equipment the Switched POPS Cabinet .
•PDU provides per outlet measurements of current, voltage, power
(kW), apparent power, crest factor, and power factor.
8-Simple Network Management Protocol (SNMP)
•SNMP is the most widely used network management solution for our
networks.
•It is an open standard-based framework that is simple but yet flexible
enough to manage many different types of devices.
o
o
With the help of this Tool we can Monitor our POP
network equipment and Horizontal Client.
Fill the IP address of horizontal and also
description.






Ping
Traceroute
Show run
Show ip int brief
Show ip protocol
Show ?
Ping is a first command to check Network
connectivity. If we phase a problem in our Network
then we use ping command to check connectivity.
 First we ping Gateway means ip configure at router
gigabit port those are connect to switch.
 If we get proper response of our gateway means
problem is not local end, after that we ping our
next hop ip(If we check network from BHQ then
next hop ip is DHQ wan ip , if we check network
from DHQ then next hop ip is CHQ wan ip and If
we check network from CHQ then next hop ip is
SHQ wan ip .
IP Address
Allocation
MPSEDC
IP address


An IP address is a 32-bit number that
uniquely identifies a host (computer or
other device, such as a printer or router) on
a TCP/IP network.
IP addresses are normally expressed in
dotted-decimal format, with four numbers
separated by periods, such as
192.168.123.132.
MPSEDC
IP Address Classification
Class
MPSEDC
Leftmost bits Start address
Finish address
A
0xxx
0.0.0.0
127.255.255.255
B
10xx
128.0.0.0
191.255.255.255
C
110x
192.0.0.0
223.255.255.255
D
1110
224.0.0.0
239.255.255.255
E
1111
240.0.0.0
255.255.255.255



We are using two IP pools 10.124.x.x/16 and
10.125.x.x/16 in our network.
From these pools ip has been created for all
horizontal and verticals location.
For ex. Gwalior district block IPs and
department IPs has been allotted as follows:-
MPSEDC
Gwailor DHQ - IP Schema
WAN IP
WAN IP Subnet
PTP
Total PTP
Tehsil/Sub
Subnet
Gigaethernet
Sr.
connecting to
Connectivity Network
Division/
connecting to
port Port IP of
No.
SHQ/DHQ (E1
for
for
Block name
CHQ/BHQ (E1
Router
Link) /30
Horizontal/30 Horizontal
Link) /30
10.124.86.2
10.124.86.4
&
10.124.87.0
127
Switch IP
address
BHQ Off
RF/LAN IP
address Range
allocated /25
10.124.88.2
10.124.88.0/24
1
Gwalior
10.124.86.1
2
Ghatigaon
10.124.89.1
10.124.89.2 10.124.89.4
31
10.124.89.129 10.124.89.130 10.124.89.128
3
Dabra
10.124.90.1
10.124.90.2 10.124.90.4
31
10.124.90.129 10.124.90.130 10.124.90.128
4
Bhitrarwar
10.124.91.1
10.124.91.2 10.124.91.4
31
10.124.91.129 10.124.91.130 10.124.91.128
5
Chinar
10.124.92.1
10.124.92.2 10.124.92.4
31
10.124.92.129 10.124.92.130 10.124.92.128
10.124.88.1
MPSEDC
Prepared ByAshish Dhote (MPSWAN)
State IT Center Bhopal