Synthesis, Separation, and Purification of Acetanilide
The Procedure
1. 1 ml of aniline added to 50 ml Erlenmeyer flask
2. 7ml deionized water was added, and while stirring, 1.25 ml of acetic anhydride was
added in small portions; acetic anhydride was properly capped after.
3. A large volume of crystals was formed.
4. Product recrystallized after adding 15mL of water and heated to boiling.
5. After stirring with a wooden stick, the stick was left in flask. The process continued until
all oil and solids were dissolved.
6. Flask was removed after all solid and oil was dissolved and was set in glass wool bath to
prolong cooling
7. After cooled, substance was placed in ice bath to maximize crystal formation
Observations
1. ~1.02 grams aniline added to flask
2. In step two, an orange/yellow mix was visible with orange/white crystals
3. In step 3, all crystals were dissolved before continuing with the experiment
4. Reaction recrystallized completely in two minutes in step 5.
5. Final product was observed with white crystals.
6. No final weight was measured due to stop in experiment.
Conclusion
The main goal of this experiment was to synthesize and obtain acetanilide from aniline and
acetic anhydride through their reaction, recrystallization of the solid for purification, and then
filtration in the later steps of the lab, which did not happen due to vacuum line malfunctions.
Each step of recrystallization further purifies the solid to produce a solution without
contaminants. In the short span of the experiment, possible sources of error could have come
from removing the stick early (which could leave solid on the stick, inadequate heating, and not
enough patience between steps involving heating and cooling. If not adequately cooled or heated,
purification is incomplete and could result in the loss or impurity of the final desired product. All
in all, while the goal of the lab was not reached, important knowledge and methods of
recrystallization were developed even though the filtration steps were incomplete.
References
(1)Auburn University, D. of C. Organic Chemistry I Lab Manual, 2025 ed.; hayden-mcneil lab
solutions.