Uploaded by henry golosino

TVL-EIM-7-FIRST-QUARTER

advertisement
Republic of the Philippines
Department of Education
TABLE OF SPECIFICATION in EIM 7
Learning
Competency
(No. of Days based
on LC Codes)
40
day
s
100
%
No.
of
Item
s
50
Lower-Order Thinking
Skills
Rememberin
g
Understandin
g
Moderate-Order
Thinking Skills
Applyin
g
Analyzin
g
High-Order
Thinking Skills
Evaluatin
g
Creatin
g
TLE_IAEI7/8UT-0a-1
LO 1. Prepare
electrical materials
and tools for the
task
10
25
%
12.5
13
10
25
%
12.5
12
10
25
%
12.5
10
25
%
12.5
TLE_IAEI7/8UT-0a-2
LO 2. Request
appropriate
electrical supplies
materials and tools
applicable to a
specific job
TLE_IAEI7/8MT-0b-3
LO 3. Receive and
inspect electrical
supplies, materials
and tools
12
TLE_IAEI7/8MT-0b-3
Create Project Plan
for Making
Extension Cord
13
First Quarter Examination in EIM 7
Name:
Teacher:
Grade Level and Section:
Date:
Score:
I. Identification. Identify each of the following, write the correct answer in your answer sheet.
A. Tools/Materials:
B. Describe/Define: Read the statement carefully and identify what is being described or
defined. Choose your answer from the words inside the box
1. This is used for griping, holding, cutting electrical wires and cables and
even small nails. Usually used by linemen in doing heavy tasks.
2. Used for cutting and holding fine wires. This can reach tight space or
small opening where other pliers cannot reach and also used in making
terminal loops of copper wires.
3. This has a cross tip resembling a positive (+) sign. It is used to drive screws
with cross slot heads.
4. This is tools used in driving or pounding and pulling out nails.
5. A tool used for removing insulation of medium sized wires ranging from
gauge #10 to gauge #16.
6. A small drilling machine with a chuck capacity of ¼‖ to 3/8‖. It is used in
making holes on metal sheets and concrete walls.
7. Comes in either Standard or Philips screw driver with short shank or blade
and shorted handle used to turn screws in tight space where standard
screwdriver cannot be used.
8. Used by linemen to remove insulation of wire and cables in low and high
voltage transmission lines.
9. Is a device inserted to a convenience outlet to conduct electric current.
A flat cord is attached to it on one end and the other end is connected
to a current consuming instrument or appliance.
10. This is a circuit protective device that automatically blows and cut the
current when an over load or short circuit happens.
11. This is a rectangular shaped metallic or plastic (PVC) material in which
flush type convenience outlet and switch are attached.
12. Are electrical materials used as the passage of wires for protection
and Insulation.
13. Are used to attach metallic or non-metallic conduit to the junction
or utility boxes.
14. This is a protective device used to automatically cut off the current
when trouble in the circuit such as short circuit or over load occurs.
15. Is an octagonal shaped electrical material where the connections or
joints of wires are being done. It is also where the flush type
lamp holder is attached.
III-Performance: Create a Project Plan in Making Extension Cord, following the format below.
Give the actual price/cost of materials. Observe proper margin and no erasures allowed. Your
output will be rated using the rubric below:
Download