HOW TO SET THE RPM ON RAKE DRIVES
1. To start, drive must be set in local. To change from Remote to Local, press LOC/REM
(#7) button. You will see the letter “L” in the top left corner.
2. Once in local, hit the REFERENCE BUTTON (#3). A set of parentheses will show up
around the RPM on the MASTER DRIVE.
3. Use the double arrows
to adjust the RPM. It will change every 10RPM.
4. When the desired RPM is on the MASTER DRIVE, press ENTER. The parentheses
will vanish and the drive should change to designated RPM. To confirm the change in
RPM, look at the FOLLOWER DRIVE and check RPM.
5. When completed, put drive back into remote and press the LOC/REM(#7) button. The
“L” will disappear from the top left corner. The drive is now in Remote.
CONTACT AN ELECTRICIAN IF THERE ARE ANY ISSUES