Remote Trainer Owners Manual III. Turning your remote train selecting operating mode Components ! Transmitter ! Receiver with collar ! Training Manual ! Owners Manual ! Video I. Assemble collar Mode automa conserv Step 1: Thread slide buckle onto the collar first. connect Important Note: Slide buckle also prevents collar from becoming loose around your dog’s neck. Important Note: Ribs must be facing up, otherwise collar will slip if it is not properly threaded. Step 2: Thread end of the collar up through the buckle. Step 3: Thread excess collar through the slide buckle to hold it in place. This will allow you to adjust your pet’s collar as he grows. connect II. Install batteries 9 volt battery 6 volt battery observe proper - polarity remove screws (2) 9 volt battery remove screws (2) Big Dog receiver 2 remove screws (2) Little Dog receiver Long Beep Locate th receiver seconds III. Turning your remote trainer on & selecting operating mode Mode 1. Automatic Shut-off. Receiver shuts off automatically after 45 minutes of non-use to conserve battery power. connect Mode 2. Manual Shut-off. Receiver remains on until manually turned off. will slip if it is connect Dog receiver After placing the receiver in mode 1, within 5 seconds of the first beep, slowly place dots together again for three seconds and then separate. Listen for two short beeps. To turn receiver off from either Mode 1 or 2, slowly place dots together for 3 seconds and then separate. Listen for a long beep. 6 volt battery remove screws (2) Locate the two dots on both the transmitter and receiver then slowly place two dots together for 3 seconds and then separate. Listen for one short beep. remove screws (2) Long Beep Little Dog receiver 3 IV. Set the correction level To Program Correction level, hold down the P button. After 2 seconds, the receiver will indicate the present correction level setting by beeping the corresponding number of times for the current level. Continue to hold the P button down until the number of beeps equals the level of correction you want. After Level 8, the receiver will go back to Level 1. Signal indicator light Correction with negative tone. Negative tone only Program button V. Placing the collar on your pet ] DO monitor your dog during initial use. \ DON’T put collar on too tight. \ DON’T leave on for extended periods of time. \ DON'T use until throughly reading the training manual. VI. Begin training Please read the training manual thoroughly and review the video before beginning training. VII. Maintenance Perform each of the following: ] Check batteries (monthly). ] Clean probes with alcohol (weekly). ] Be sure that the probes are tightened securely to the receiver (monthly). ] Check your pet’s neck for any irritation (daily). Caution: To reduce risk of electric shock, DO NOT REMOVE COVER. Refer to qualified service personnel. Risk of fire. Risk of electric shock. Install Transmitter indoors. Do Not expose to rain. 14VAC 1.8A This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device must not cause harmful interference 2. This device must accept any interference received including interference that may cause undesired operation. FCC ID: KE3IF100 Radio Systems Corporation, 10427 Electric Ave., Knoxville, TN 37932 1-800-732-2677 www.radiosys.com 4 400-206/B