DEPARTMENT OF
WORKSHEET-3.3
Name: Pushpendra Kumar
Branch: CSE
Semester: 4th
Subject Name: Computer Networks
UID: 22BCS80081
Section/Group: 912-A
Date of performance:
Subject Code-21CSH-256
Aim:
Configuration of TCP/IP Protocols.
Requirements:
Cisco Student Packet Tracer
Algorithm/Flowchart (For programming-based labs):
1. Launch the simulator.
2. Plot two routers, two switches and some end devices (PCs and Laptops) where
end devices are connected to switch, which is further connected to the routers
and then the routers are connected with each other via automatically chosen
wired connectors. The connections should be made according to the diagram
shown below.
DEPARTMENT OF
COMPUTER SCIENCE & ENGINEERING
3. Give IP addresses to all the end devices and provide IP address to the router
same as that provided to the default gateway of the end devices in the correct
Ethernet port.
DEPARTMENT OF
COMPUTER SCIENCE & ENGINEERING
DEPARTMENT OF
COMPUTER SCIENCE & ENGINEERING
4. Configure the Serial Interface port status to on and set the clock rate after
providing Serial IP. Set the Network, Mask and Next Hop addresses for each
router. Then click on Add.
Result/Output/Writing Summary:
Understood how Cisco Packet Tracer works to configure TCP/IP Protocol in a
network.
DEPARTMENT OF
COMPUTER SCIENCE & ENGINEERING
Learning outcomes (What I have learnt):
1. Know about how the data is transfer through computers.
2. Uses of switches (Can be used) and routers.
3. Knowledge about address like IP, default, static routing, etc.
4. Knowledge regarding TCP/IP.
5. Some knowledge about port status, subnet mask.