Polyether amine Genamin® D 01/2000 Clariant International Ltd BU Industrial & Consumer Specialties Rothausstrasse 61 4132 Muttenz Switzerland Sales & Marketing Phone: +41 61 469 7704 Application Development Phone: +49 8679 717 020 www.clariant.com www.Paints-Coatings.Clariant.com This information corresponds to the present state of our knowledge and is intended as a general description of our products and their possible applications. Clariant makes no warranties, express or implied, as to the information’s accuracy, adequacy, sufficiency or freedom from defect and assumes no liability in connection with any use of this information. Any user of this product is responsible for determining the suitability of Clariant’s products for its particular application. * Nothing included in this information waives any of Clariant’s General Terms and Conditions of Sale, which control unless it agrees otherwise in writing. Any existing intellectual/industrial property rights must be observed. Due to possible changes in our products and applicable national and international regulations and laws, the status of our products could change. Material Safety Data Sheets providing safety precautions, that should be observed when handling or storing Clariant products, are available upon request and are provided in compliance with applicable law. You should obtain and review the applicable Material Safety Data Sheet information before handling any of these products. For additional information, please contact Clariant.® Trademark of Clariant registered in numerous countries. * For sales to customers located within the United States and Canada the following applies in addition: NO EXPRESS OR IMPLIED WARRANTY IS MADE OF THE MERCHANTABILITY, SUITABILITY, FITNESS FOR A PARTICULAR PURPOSE OR OTHERWISE OF ANY PRODUCT OR SERVICE. ©2016 Clariant International AG, Rothausstrasse 61, 4132 Muttenz, Schweiz ®Product and service marks protected by Clariant Polyether amine Genamin® D 01/2000 Clariant polyether amines are multifunctional, easy to handle products containing terminal primary amino groups attached to a polyether backbone based on propylene oxide (PO) or a mixture of ethylene oxide (EO) and propylene oxide (PO). Genamin® D 01/2000 is a diamine based on polypropylene glycol with an average molecular mass of 2000 g/mol. Thus, Genamin® D01/2000 is a hydrophobic building block and is used as reactive component and/or curing agent in various applications. Product specifications Applications Polyurea sprays & isocyanatefree polyurethanes Polyamide & epoxy adhesives Epoxy coatings Product properties Benefits High primary amine value, i.e. high AHEW (amine hydrogen equivalent weight) > assures robustness of end-product due to high crosslinking density Low viscosity > improves flow & levelling Narrow molecular weight distribution > enables to reach high quality standards Hydrophobic diamine > increases water resistance High molecular weight polyether backbone > improves flexibility and toughness > increases peel strength Moderate reactivity > optimizes open-time of epoxy formulations Low water content > less side-reactions during synthesis > higher purity of end-products Very low color > reduces yellowing effects in coatings Elastomers, thermoplastics & coatings Composition Polypropylene glycol ether diamine Molecular weight approx. 2000 g/mol AHEW approx. 500 g/eq. Chemical structure H2N O 33 NH2 Active substance approx. 100% Appearance at 20 °C Colorless to yellowish, clear viscous liquid Density at 20 °C approx. 0,995 g/cm3 Viscosity at 20 °C approx. 325 mPa*s Amine number 52 – 57 mg KOH/g Primary Amine content min. 97% pH value (1% in water) approx. 10,4 Water content max. 0,1% Pour point < - 20 °C Registration status Australia (AICS) Canada (DSL) Europe (REACH status Clariant) Japan (ENCS) China (IECSC) + + + + + Korea (KECI) Taiwan (NECI) New Zealand (NZIoC) Philippines (PICCS) USA (TSCA) + – + + + Clariant International Ltd BU Industrial & Consumer Specialties Rothausstrasse 61 4132 Muttenz Switzerland Sales & Marketing Phone: +41 61 469 7704 Application Development Phone: +49 8679 717 020 www.clariant.com www.Paints-Coatings.Clariant.com This information corresponds to the present state of our knowledge and is intended as a general description of our products and their possible applications. Clariant makes no warranties, express or implied, as to the information’s accuracy, adequacy, sufficiency or freedom from defect and assumes no liability in connection with any use of this information. Any user of this product is responsible for determining the suitability of Clariant’s products for its particular application. * Nothing included in this information waives any of Clariant’s General Terms and Conditions of Sale, which control unless it agrees otherwise in writing. Any existing intellectual/industrial property rights must be observed. Due to possible changes in our products and applicable national and international regulations and laws, the status of our products could change. Material Safety Data Sheets providing safety precautions, that should be observed when handling or storing Clariant products, are available upon request and are provided in compliance with applicable law. You should obtain and review the applicable Material Safety Data Sheet information before handling any of these products. For additional information, please contact Clariant.® Trademark of Clariant registered in numerous countries. * For sales to customers located within the United States and Canada the following applies in addition: NO EXPRESS OR IMPLIED WARRANTY IS MADE OF THE MERCHANTABILITY, SUITABILITY, FITNESS FOR A PARTICULAR PURPOSE OR OTHERWISE OF ANY PRODUCT OR SERVICE. ©2016 Clariant International AG, Rothausstrasse 61, 4132 Muttenz, Schweiz ®Product and service marks protected by Clariant
