Drawings Review Check List
DOC ID:
DCL-<P.Num>-<YYMMDD>-nnnn
<YYMMDD>-nnnn
Part / Drawing description:
No
Part / Drawing No.:
Check / Action
E8
E9
ENGINEERING CHECKS
Make sure that all required information is available
- Mechanical
- Electrical
- Environmental
- Materials + Finish + relevant standards
- Other [
]
Check the design for interference issues
Check the design for components assembly and
disassembly functionality.
Check the design for stress and strain when
considerable force is to be applied.
Conduct thermal analysis, if applicable.
Check that the general tolerance matches the part
design style
Ensure manufacturability and maintainability
considerations are addressed
Any jigs needed to test the part?
Any tests performed to verify the change?
G1
G2
G3
G4
G5
G6
G7
GENERAL CHECKS
Revision complies with required revision?
Title is correct, same as in PDM / SAP / BOM
Revision table is complete with DCN details
Pack and Bag note exists? Is correct?
Relevant standards are called out correctly?
Interference issues between parts were resolved?
Scale in the block matches the actual views scale?
E1
E1.1
E1.2
E1.3
E1.4
E1.5
E2
E3
E4
E5
E6
E7
P1
P2
P3
P4
P5
Check
Deviation / Finding
V, X, NA
PART DRAWINGS
Material and finish are defined?
Dimension balloons exists?
No duplicate dimensions?
General Tolerance is defined and reasonable for the
part
For jigs – is the P/N engraved on the part?
Summary / Result:
Inspected / checked by:
 PASS
 FAIL
Corrected by:
 Other
Verified by:
Checklist ID: GD000000-15-7654
Rev: A
Signature:
Date:
Page: 1 of 1
Rev.
Fixed /
Rej.