Push Block
©Woodworking for Mere Mortals
Push Block
©Woodworking for Mere Mortals
Push Block
3/4” Plywood
Handle seat (channel)
3/4” Plywood
2x4 scrap lumber
1/4” Plywood
©Woodworking for Mere Mortals
Push Block
Cut dado in oversized board.
This can be any width, just make it
wide enough to control cutting the
dado with your fingers out of the way.
©Woodworking for Mere Mortals
Push Block
Cut handle seat to width and drill holes near the ends.
©Woodworking for Mere Mortals
Push Block
Cut and shape handle using a jigsaw.
©Woodworking for Mere Mortals
Push Block
Full size cutting template.
©Woodworking for Mere Mortals
Push Block
Cut 2x4 block to any length you want.
Cut cleats out of 1/4” plywood and drill holes for screws.
Make extra cleats to have on hand.
©Woodworking for Mere Mortals
Push Block
Attach handle and cleat.
Use 1” screws and
washer to attach
the handle.
Use 1” screws to
attach the cleat.
©Woodworking for Mere Mortals
Push Stick
©Woodworking for Mere Mortals
Push Stick
©Woodworking for Mere Mortals