JO/ HC 109/PO 10
Doc. No.
Sub-Center Field Operations Office
Rev:
Job Safety Analysis
Page
001
1 of 4
Job name/number:
Loading/Unloading of Site
Office using Crane
Division/section: Job crew:
POD
Date:
15/06/2001
Revised
Job Location :
Wafra Field
Asset Owner contact (Name and Tel.):
Compiled By :
HSE Officer
Ali Farahan
Reviewed By:
Eng: Nawal Attwa
Eng. Raj 66933178
Personal Protective Equipment:
Hard hat, Eye protection (safety googles),
Gloves, Ear Plug, Work boots & H2S
monitors.
Other Safety/E
emergency Equipment Required:
Multi Gas Monitor, Fire Extinguishers & First aid Kit.
Sequence of Job Components & Tasks
Potential Hazards, Concerns
Safe Practice/Procedure
New
1. Pre job planning and preparation
7.Clean work site, Work Completed, final
thorough check up, hand over
•
All necessary tools &
equipment available and
in good condition and
functioning.
• Heat stress if work carried
out during summer.
Incorrect placing
•• Simultaneous/conflicting
operation, condition such
loading/unloading,
rig
working
near
by
Grinding/Welding/Lifting
/Cutting old line at work
site.
•
Ensure that appropriate permit to work is in
place and work site thoroughly inspected, get
familiar with other obstruction.
• Conduct tool box meeting and explain expected
hazards and necessary precautions.
• All necessary tools & equipment available and in
• good
Correct
missingand
item.
condition
proper functioning.
•
Remove
all
surplus
supports,
pipes,
trashes.
• Maintain a comfortable
distance
from
different
work activities, be more attentive make aware of
your work to other crew.
• Maintain minimum distance of 4 meters from
overhead power line.
• Check surrounding area, ground condition, wind
condition, overhead power lines.
•
•
•
2.Setting Crane for the load to be lifted
•
•
Hand Injury to the rigger.
Failure of slings or Dshackles.
•
•
•
3.Lifting the load
•
•
•
Lifted material falling.
Hitting people or existing
facility.
Crane losing balance.
•
•
•
•
•
•
•
•
Check lifting capacity of Crane and radius of
operation.
Ensure Crane is placed on hard, level ground,
outriggers fully extended and placed under
timber mats.
Ensure the Crane is having spark arrester when
working in restricted area
Keep hands out of pinch point while rigging,
Use hand gloves.
Know the weight to be lifted and its
configuration, Check Weather condition ,
Wind speed(low, high)
Emphasis more to STOP WORK if they see
anything unsafe.
Barricade the area of Crane operation place
warning.
Check rigging before lifting.
Ensure lifted load is properly balanced.
Stop lifting if wind is getting strong and poor
visibility.
Refer to load chart and radius of operation.
Assign one man to give signal to crane operator.
Use tagline to control suspended load.
Use safety glasses, gloves. Keep other people
I have reviewed JSA at site and discussed with all workers
Signature of permit user: