Congratulations on receiving your brand new
AKS
DMX WIRELESS SYSTEM
Powered by
Imagine controlling your lighting levels without wires using your iPhone or tablet. Whether you’re
using the AKS from your DIT tent, follow car or right on set,
you have full control.
The AKS is small enough to fit in your hand but has a powerful router, a CRMX transmitter, and a
DMX node
all in one. With over 20 hours of battery on just a 5 hour charge time, you will always be ready.
LuminRadio’s CRMX technology gives the AKS over 1,200 feet of range to the lights, and uses 128bit encryption and error correction to ensure a clear signal no matter what.
Long range WiFi allows your tablet or phone to control the AKS from up to 250 feet away, and the
Ethernet port interfaces with most modern consoles and PC-based DMX software. The included
L2-Net Ethernet cable allows iOS devices with Luminair 3 software to work with the AKS even if the
WiFi environment is saturated.
Setup is simple; turn on the AKS, go to your device’s WiFi settings and chose RatPac AKS as your
wireless network, turn on your DMX app and you’re ready to go!
AKS
DMX WIRELESS SYSTEM
INSTRUCTIONS
Turn on the AKS by holding down the power button for 5 seconds.
Press the RF Link button to instantly connect to any unlinked CRMX Wireless device within range.
The AKS works with all CRMX wireless devices, including the Ratpac Cintenna,
all wireless Ratpac dimmers and any compatible CRMX or LuminRadio products.
Choose “Ratpac AKS” in your mobile device settings, then open your Art-Net compatible DMX app and start lighting your set.
Most apps will auto-configure. The default IP of the AKS is 10.10.100.254.
Be sure to close all other open apps for best performance!
If errors occur, restart your device WiFi or move the AKS closer to the paired WiFi device.
If you are using Luminair 3 for iOS, an Apple-certified L2-Net Ethernet to Lightning cable is included in the kit for a hard link in tricky
WiFi scenarios. WiFi may need to be enabled on the device to initialize the L2-Net cable.
Advanced users can configure their consoles or lighting computers for direct ethernet Art-Net operation.
The AKS includes a rapid USB charger and can also charge and operate simultaneously.
The Lo-Batt indicator will illuminate when the device needs to be charged.
FCC Declaration of Conformity
We LumenRadio AB Svangatan 2B, 41668 Gothenburg, Sweden, declare under our sole responsibility that 800-8105, TiMo RX RDM and 800-8106, TiMo FX RDM, comply with Part 15 of FCC Rules. Operation is
subject to the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may cause undesired operation.
FCC Radio Frequency Interference Warnings & Instructions
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following methods:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment into an electrical outlet on a circuit different from that which the radio receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
Modifications made to the product, unless expressly approved by LumenRadio AB and Innovative Dimmers LLC.,
could void the user’s right to operate the equipment.
Recycvling and Disposal: Device contains Li-ion battery, do not discard in trash.
For disposal, please deposit at an appropriate recycling facility or simply send to:
Ratpac Dimmers
7508 Tyrone Ave
Van Nuys, CA 91405
Industry Canada statement
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.
Le resent appareil numerique német pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la classe B prescrites dans le Réglement sur le broullage radioélectrique édicté par le
ministére des Communications du Canada.
CE
800-8105 TiMo RX RDM and 800-8106 TiMo FX RDM comply with the Essential Requirements of RED (Radio Equipment Directive) of the European Union (2014/53/EU). TiMo RX RDM and TiMO FX RDM meet the
ETSI EN 300 328 V1.8.1 and ETSI EN 300 328 V1.9.1 conformance standards for radio performance.
FCC ID:XRSCRMXTIMO101
FCC ID:AZYHF-A11X
FCC ID:AZYHF-A21X
No User Serviceable parts inside.
Contains UN DOT 38.3 Compliant Lithium Ion Battery (10400mAh).
Please follow proper disposal and recycling procedures.
Manufactured by
INNOVATIVE DIMMERS LLC
7508 Tyrone Ave.Van Nuys, CA 91405
(818) 786-0536
Copyright ©2015 Innovative Dimmers LLC., All Rights Reserved