SP1 Upgrade Kit - Architectural Area Lighting

advertisement
SP1-LK – Spectra Large Scale – LED Upgrade Kits
•
•
•
•
Reliable, efficient operation
Type 2, 3, 4, 5 distributions
3000K, 4200K and 51v00K CCT
Integral surge protection
1. UPGRADE KIT
2. OPTICAL SYSTEM
SP1-LK
•
•
13 standard powder coat finishes
IP66 optics
3. COLOR
TEMPERATURE
3. COLOR TEMPERATURE
SP1-LK Spectra 32 LED upgrade kit
32LED-3K (Warm White, 3000K output)
32LED-4K (Neutral White, 4200K output)
32LED-5K (Bright White, 5100K output)
2. OPTICAL SYSTEM
LED
Y3-32LED (Type 3)
Y4-32LED (Type 4)
SP1
4. DRIVER
1. UPGRADE KIT
Y2-32LED (Type 2)
TYPE
4. DRIVER (120 thru 277 volt)
550 (57 watts)
Y5-32LED (Type 5)
SPECIFICATIONS
OPTICAL MODULE
• Light emitting diode (LED) assembly shall be
sealed to a die-cast anodized aluminum heat
sink with an injection molded silicone rubber
gasket and stainless steel bezel, IP66.
• LED optics shall be injection molded PMMA
acrylic and be mounted to a metal printed
circuit board with a uniform conformal coating
over the panel surface and electrical features.
ELECTRICAL
• Upgrade kits shall accept 120 thru 277
50/60Hz input voltage, and have integral surge
protection
• Existing luminaires may not have 0-10V control
leads in place prior to the upgrade kit, consult
factory for dimming and control solutions.
• Drivers shall be U.L recognized, have a
minimum starting temperature of -30°C and
have a 0-10v dimming interface with a dimming
range of 10-100%.
• Drivers shall have a power factor ≥.90 and
THD of ≤20% at full load with an inrush current
maximum of <20.0 Amps maximum at 230VAC.
• Drivers shall not be compatible with current
sourcing dimmers, consult factory for current list
of known compatible dimming systems
• Approved dimmers include Lutron Diva AVTV,
Lutron Nova NFTV and NTFTV.
• LifeShield™ shall be provided with all
configurations for added protection in the
event of abnormally excessively high ambient
temperature conditions.
• Surge protector shall be U.L. recognized and
have a surge current rating of 10,000 Amps
using the industry standard 8/20uSec wave and
surge rating of 372J.
ARCHITECTURAL AREA LIGHTING
16555 East Gale Ave. | City of Industry | CA 91745
P 626.968.5666 | F 626.369.2695 | www.aal.net
Copyright © 2012 | REV 7.16
JOB
TYPE
NOTES
| 1 |
SP1 - SPECTRA LED Large Housing Scale
| Type
Kits
SP1-LK – Spectra Large Scale – LED Upgrade
SPECIFICATIONS
(continued)
TYPE
DIMENSIONS
CERTIFICATION
•
Luminaire shall be listed with ETL for outdoor,
wet location use, UL1598, UL 8750 and
Canadian CSA Std. C22.2 no.250. IP65.
WARRANTY
•
Luminaire housing, finish and optical module
shall be warranted for five years.
•
Driver, surge protector and electrical
components carry the component
manufacturer's limited warranty.
•
Any unauthorized return, repair, replacement or
modification of the Product(s) shall void this
warranty.
•
This warranty applies only to the use of the
Product(s) as intended by AAL and does not
cover any misapplication or misuse of said
Product(s), or installation in hazardous or
corrosive environments.
6.81
SP1
DIAMETER:
ANG
FLR
STR
DBL
22” / 559mm
27” / 686mm
31.5” / 801mm
31.5” / 801mm
##
##
##
##
EPA:
HEIGHT:
29.6” / 741mm
WEIGHT:
30 lbs.
PERFORMANCE DATA
Y2
4129 72.4 1 2 4K
1 3948 69.3 1 2 13K 3041 53.4 AMPS@
1 2
5K
Y3 (clear) 3964 69.5 1 2 1 3790 66.5 1 2 1 2920 51.2 120VAC
1 2
LUMENS
LPW
U G73.3
LUMENS
B U 70.1
G LUMENS
B U54.0
G 1 2
std. B4177
Y4
1 2 LPW
1 3994
1 2 LPW
1 3077
Y5
2 2 69.3
1 3640
2 2 53.4
1 2804
Y2
4129
72.4 13807
2 166.83948
1 2 63.9
1 3041
1 249.2
1 2 2
32 550
57
Y2
1 2 66.5
1 3323
1 2 51.2
1 2549
Y3 Clear
3964
69.5 13461
2 160.73790
1 2 58.3
1 2920
1 244.7
1 10.52
Y3
1 2 70.1
1 3138
1 2 54.0
1 2407
Y4 (std.)
4177
73.3 13268
2 157.33994
1 2 55.1
1 3077
1 242.2
1 1 2
LDL
Y4
1 2 63.9
1 3347
1 2 49.2
1 2567
Y5
3807
66.8 23486
2 161.23640
2 2 58.7
1 2804
2 245.0
1 1 2
Y5 5100K 3195 56.1 2 24200K
CCT AVERAGE
1 3068 53.8 2 2 3000K
1 2353 41.3 1 2
5K 3800K-4600K
4K 2800K-3175K
3K
CCT RANGE
4600K-5600K
CRI MINIMUM
CCT Average ≤70
3000K
4200K
5100K
≤70
≤80
CCT Range
2800K – 3175K
3800K – 4600K
4600K – 5600K
CRI Minimum
≤70
≤70
≤70
TYPE
LENS
SP1-FLR-Y5-32LED-5K-550
SP1-FLR-Y5-32LED-5K-700
Amps @ 277 VAC
B U G
Amps @ 120 VAC
LPW
B U CURRENT,
G
B U G
PERFORMANCE DATA (32 LEDS, 550 MA DRIVE
57 WATTS)
3K
LUMENS
LPW
LUMENS
4K
LPW
LUMENS
LENS
DISTRIBUTION
TYPE
SYSTEM WATTS
5K
DRIVE CURRENT
(MILLIAMPS)
•
The electrical assembly shall be mounted to a
prewiredshall
internal
service tray
and
accessed
• Existing luminaires
be required
to be
taken
down by
loosening
twolens,
captive
boltsand
andballast.
lifting off the top
for disassembly
of outer
optics
of the luminaire.
• Estimated time for installation of the upgrade kit into an
existing
luminaire
is 25 MOUNTING
minutes.
ARM
AND POLE
•
The pole mounted arm for a single fixture (SAP)
and pole mounted arm for two fixtures at 180°
SERVICING (TAP) shall have a cast aluminum post top and
fixture fitter with two round horizontal stainless
• The electrical
assembly
steel
bars. shall be mounted to a prewired
internal
tray and
by loosening
two pole
• service
The post
fitteraccessed
shall slip over
a 4"/100 mm
and
belifting
secured
six of
stainless
steel set
captive bolts
and
off with
the top
the luminaire.
screws.
•
The wall mounted arms for a SP1 fixture shall
have a cast aluminum wall plate, cover and
CERTIFICATION
fixture fitter with two round horizontal stainless
Upgrade kits shall
listed
with
ETLshall
for outdoor,
steelbe
bars.
The
cover
secure towet
the wall
plate
with four
set screws.
location use,
UL1598,
UL stainless
8750 andsteel
Canadian
CSA Std.
C22.2 no.250. IP65.
FINISH
•
Luminaire finish shall consist of a five stage
pretreatment regimen with a polymer primer
WARRANTY / sealer,
TERMSoven
ANDdry
CONDITIONS
OF SALE
off, and top coated
with a
Download:
thermoset super TGIC polyester powder coat
finish.
http://www.hubbelllighting.com/resources/warranty/
•
Luminaire finish shall meet the AAMA 605.2
performance specification which includes
passing
hourproduct
salt spray
test for corrosion
AAL reserves the
right ato3000
change
specifications
without notice.resistance.
DIMENSIONS
NUMBER OF
LEDS
SERVICING
INSTALLATION
AMPS@
1
277VAC
1
1
1
.5
1 0.2
1
1
1
.2
SP1-FLR-Y3-32LED-5K-550
SP1-FLR-Y3-32LED-5K-700
AAL reserves the right to change product
specifications without notice.
12’ MOUNTING HEIGHT
12’ MOUNTING HEIGHT
IES files can be found at www.aal.net AMBIENT TEMP.
0
25,000
PROJECTED LUMEN MAINTENANCE
AMBIENT
25°C/
100% 25,000 96%
0
TEMP.77°F
25°C/77°F
100%
96%
40°C/
104°F
40°C/104°F
100%
100%
94%
94%
50,000
94%
50,000
94%
91%
91%
*TM-21-11
60,000
100,000
*TM-21-11
93%
60,000
93%
90%
100,000
90%
86%
90%
90%
86%
PROJECTED
L70 (HRS)
PROJECTED
>60,000
L70 (hours)
>60,000
>60,000
>60,000
IES files can be found at www.aal.net
ARCHITECTURAL AREA LIGHTING
16555 East Gale Ave. | City of Industry | CA 91745
ARCHITECTURAL
AREA |LIGHTING
P 62.6968.5666
F 626.369.2695 | www.aal.net JOB
Copyright
© 2013
| REV
130812 | CA 91745
16555 East
Gale Ave.
| City
of Industry
TYPE
P 626.968.5666 | F 626.369.2695 | www.aal.net
NOTES
Copyright © 2012 | REV 7.16
JOB
TYPE
NOTES
| 2 |
| 2 |
Download