Specifications TERTEK 4G/LTE SAFE
LED color
Yellow
4G/LTE Safe
Yes
TETRA Safe
Yes
Color Selection
Red, White, Yellow
Noise figure
<3,0 dB
Max. Output Level
108/104 dBµV
Power Consumption
50mA
Width
190 mm
Height
120 mm
Channel
DVB-T/T2/FM/DAB/DAB+/5-12/21-60
Elements
1+ pcs.
Impedance
75 Ohm
Power Supply
12/230 volt
5 Volts from receiver
Yes
Band
BIV/V
Opening angle Hor.
360 degrees
Opening angle Ver.
180 degrees
Wind load
5.5 N
Frequency Range DAB 174-300Mhz
Frequency Range FM
87,5-108Mhz
Connector
F-Connector
Frequency Range VHF 174-300Mhz
Frequency Range UHF
470-790Mhz
Combi Marine
TERTEK Marine 4G/LTE TETRA SAFE
Digital Antenna Installation instructions
Vertikal
Horizontal
TERTEC Evolution® GmbH - Grosse strasse 42-44 - 24937 Flensburg
Tlf. +49 (0)461 182 8149
Reception
support@tertec-evolution.eu
Start by removing the old antenna, put the adapter on the mast and tighten the screw Pinol.
Collector to extend the cable.
When installing the antanna it is important to use Sikaflex,
to ensure atder not leaks.
Mount the antenna, put the cable through the hole on the side of the adapter.
Important: fit F-Connector, strip antenna cable and make sure it is not shorted.
F-Connector fitted after the cable is pulled through the mounting surface.
The amplifier is connected to 12 or 220 volts when connected to 12 volts
be black wire to - and the black / white wire to +.
The cable from the antenna connected to the input "ANT" with f-con connector.
There are 2 outputs for TV / radio, "TV1" and "TV2", these can
split to multiple outputs, if required.