IP Module Quick Installation Guide
The IP module is shipped from the factory with the following static IP configuration:
IP Address:
192.168.0.70
Subnet Mask:
255.255.255.0
Default Gateway:
0.0.0.0
You can change these setting by using the psetup.exe program which can be found on
the CD-ROM included with the IP module.
1. Connect the IP module to a computer or laptop using a standard Ethernet cable.
2. From the connector computer or laptop, run psetup.exe to look for IP module.
3. Select device under Device MAC address. If there is more than one device you
can locate the MAC address on the label on the bottom of the IP module.
4. Click on Query Device to refresh the device list.
IP Module Quick Installation Guide
Configure Static IP Address
1. Ensure “IP auto configuration” is set to “None”
2. Enter your IP address and Subnet mask
3. Enter Supervisor user login and password for Authentication
default user name is super
default password is pass
4. Click on Setup Device. If the super user login was authenticated, it will display
“Successfully configured device”.
Enable DHCP
1. Change “IP auto configuration” to DHCP
2. Enter Supervisor user login and password for Authentication
default user name is super
default password is pass
3. Click on Setup Device. If the super user login was authenticated, it will display
“Successfully configured device”.
Unplug computer or laptop from the IP module.
Connect IP module using a standard Ethernet cable to your LAN (Local Area Network)
Please refer to the “ServerLink IP Module User Manual” included
on CD-ROM for detailed setup and operation