ILEDS80B JOB NAME CATALOG NUMBER 9” Die-Cast LED Step Light NOTES TYPE 9 1/4” 4 1/8” 3 5/16” -OP: Half Moon 3” 8” WET LOCATION -AG: Angled Louver -G: Louver FEATURES --Thermal protection integral to ballast --Heavy duty, low profile aesthetic louver trim included Order Matrix | Example: ILEDS80BW-OP A A ILEDS80 B B SU C B Series 3W LED Step Light Finish Black Powder Coated Surface™ 1 C D D Voltage blank 120V/277V E Face Plate -G Louver -AG Angled Louver -OP Half Moon CCT W 6000K NW 3000K Notes: 1. See Surface™ simulated natural finishes submittal sheet for specification. E DESCRIPTION The ILEDS80B series step light offers a black die-cast aluminum wall mount step light with 3 optional faceplates. The fixture is rated for outdoor use in concrete or blocks walls and offers low profile, safe illumination. LED LIGHT ENGINE --3W LED --3000K or 6000K --50,000 hours L70 FACE PLATE The faceplate is available in louver, angled louver, and half moon. Each trim is constructed from heavy duty die cast aluminum. Faceplates are available in black only. HOUSING The housing is constructed of die-cast aluminum with less than .3% copper to prevent corrosion. The housing comes standard with two ½” threaded knockouts to accept the power feed. Housing comes standard with captive stainless steel fasteners and a molded silicone gasket. MOUNTING For wall recessed mounting only. For use in concrete or block wall construction. Insulation must be kept at least 3” away from all surfaces of lighting fixture. SURFACE™ SIMULATED NATURAL FINISHES --Available in 8 standard wood grain powder coated finishes --Consult factory LISTING/WARRANTY --ETL Listed to US and Canadian standards for wet locations. --5-Year Intense LED Limited Warranty STEP LIGHTING L/M-048:16 P-5 Intense Lighting 3340 E La Palma Ave, Anaheim, CA 92806 | tel 714 630-9877 | fax 714 630-9883 ©2016 Intense Lighting, LLC. All rights reserved. Subject to change without notice.