lambretta electronic conversion

advertisement
LAMBRETTA ELECTRONIC CONVERSION - BEEDSPEED WIRING LOOM.
12 VOLT AC LIGHTING WITH ORIGINAL BATTERY TYPE SET UP
12 V DC - HORN, BRAKE LIGHTS, PARKING LIGHTS, PILOT LIGHTS or AUXILLARY LIGHTS
with optional FRONT BRAKE LIGHT.
GREY OPTIONAL DC HEADSET SUPPLY FOR PARKING
AND AUXILLARY LIGHTS. INTENDED FOR USE WITH 4
POSITION DC IGNITION SWITCHES. CONNECT TO BLUE
OR GREY ON DC TYPE IGNITION SWITCH - LEAVE
INSULATION SLEEVE ON IF NOT USED.
BLACK ( REAR LIGHT SUPPLY )
REAR BRAKE LIGHT SWITCH
GREY - DC SUPPLY
HEADLIGHT
JUNCTION BOX
PINK
REAR LIGHT UNIT
PINK
BROWN - MAIN LIGHTS SUPPLY
GREY - DC SUPPLY WIRE
BRAKE LIGHT / HORN)
GREEN ( IGNITION CUT OUT )
WHITE FROM
HORN BUTTON
OPTIONAL DC FRONT
BRAKE LIGHT SWITCH
LEAVE INSULATION SLEEVES
ON IF NOT USED.
BLACK
EARTH
_
8 AMP FUSE
CAN BE FITTED
HERE
LIGHTING / CHARGING
REGULATOR BOX
+
B+
RED
BROWN AC POWER SUPPLY
GREY - DC SUPPLY
HORN
ALAN BEED
EARTH
BROWN OR
YELLOW
WHITE
STATOR PLATE
RED
GREEN
IGNITION SWITCH
OFF
PARKING LIGHTS
ON
PILOT LIGHTS
TO SET THE IGNITION TIMING :
GRAY or BLUE
ORANGE - MAIN
RED
ELECTRONIC HT COIL
BLACK
YELLOW - PILOT
GREEN
BROWN
MAIN LIGHTS
EARTH
IF THE BATTERY IS NOT BEING USED AT
ANY POINT AND IS DISCONNECTED.
THE RED DC WIRE THAT POWERS THE
BATTERY ETC. CAN BE CONNECTED IN
WITH THE BROWN AC POWER WIRE AT
THE REG BOX TO POWER THE HORN
AND BRAKE LIGHT ETC.
ALAN BEED
BOLT THE STATOR PLATE DOWN IN THE CENTER OF ITS ADJUSTMENT SLOTS,
FIT THE FLYWHEEL AND POSITION THE PISTON AT TOP DEAD CENTER (TDC),
PAINT A WHITE MARK ACROSS THE FLYWHEEL AND THE MAG FLANGE AT ANY
POINT THAT IS EASY TO VIEW, THIS IS NOW THE "TDC" MARK.TURN THE
FLYWHEEL BACK ANTI CLOCKWISE THE REQUIRED AMOUNT OF DEGREES
BEFORE TOP DEAD CENTRE (19).THEN MAKE ANOTHER MARK ON THE MAG
FLANGE IN LINE WITH THE TDC WHITE MARK ON THE FLYWHEEL,
THIS IS NOW THE "TIMING" MARK AND THIS IS THE POINT WHERE THE SPARK
SHOULD OCCUR.CHECK THAT THE IGNITION TIMING IS CORRECT USING A
STROBE LIGHT. THE WHITE MARK ON THE FLYWHEEL SHOULD CLEARLY LINE
UP WITH THE BTDC WHITE TIMING MARK ON THE MAG FLANGE.
IF NOT THEN ADJUST THE STATOR PLATE AS NECESSARY.
BEEDSPEED.COM
WWW.
Download