Model 164/251 Rear SAM control unit Rear SAM control unit (N10/8) shown on model 164 P54.21-2597-00 Location Removal/installation The rear SAM control unit (N10/8) is located on the wheelhouse in the right side of the trunk. The work instructions are documented in WIS: f54.21-P-1269GZ Model 164.1 f54.21-P-1269RT Model 251 Tasks Control Workshop Information System (WIS) Exterior lights function, master control unit for the turn signal functions Model 164.1 n82.10-P-0999GZ Model 251 nCurrently not documented Interior lights (IBL) Model 164.1 n82.20-P-0998GZ Model 251 nCurrently not documented Wiper system (WSA) 12 Model 164.1 n82.30-P-0998GZ Model 251 nCurrently not documented b Overview of SAM Control Units/Current Passenger Car Model Series 2005 – This printout will not be recorded by the update service. Status: 08 / 2005 – Control Workshop Information System (WIS) Heated rear window (HHS) Model 164.1 n67.29-P-0998GZ Model 251 nCurrently not documented Model 164/251 Rear SAM control unit Central locking (CL [ZV]) Model 164.1 n80.20-P-0996GZ Model 251 nCurrently not documented Anti-theft alarm system (ATA [EDW]) Model 164.1 n80.50-P-0999GZ with code (551) Anti-theft alarm system (ATA [EDW]) Model 251 nCurrently not documented Power windows (EFH) (pop-out windows only) nCurrently not documented Model 251 Switching of consumers • • • • • • • • • • • Left taillamp (complete) Right taillamp (complete) License plate illumination Center high-mounted stop lamp Trailer illumination (with code 550) Left/right rear door inside handle illumination Left/right rear door exit lamp Load compartment illumination Right rear door central locking motor Rear-end door actuation central locking motor Fuel filler flap central locking motor • Rear door locking unit • Alarm signal horn I • Alarm signal horn with additional battery via interface (with code 551) • Lumbar pump (with code 404 or 405) • Rear-end door ambient lamp (model 251) Overview of SAM Control Units/Current Passenger Car Model Series 2005 b – This printout will not be recorded by the update service. Status: 08 / 2005 – 13 Model 164/251 Rear SAM control unit Scanning of switches, pickups and sensors Switching the following relays • • • • • • • • • • • • • • • • • • • • • • Circuit 15 Circuit 54 (stop lamp) Fuel tank sensor 1 Fuel tank sensor 2 Driver door actuation central locking motor, rotary tumbler Front passenger door actuation central locking motor, rotary tumbler Left rear door central locking motor, rotary tumbler Right rear door central locking motor, rotary tumbler Rear door locking unit TAG rear-end door lock contact switch Signal radio LF radio antenna interference filter ATA [EDW] hood switch (with code 551) Automatic loading floor switch (model 164 with code 942) CL [ZV] radio receiver Alarm signal horn with additional battery via interface (with code 551) Circuit 15R relay Circuit 15Rx relay (power outlets) Heated rear window relay Rear wiper relay Trailer circuit 15R relay Deluxe seat relay Electric loading floor retract relay (model 164 with code 942) • Electric loading floor extend relay (model 164 with code 942) CAN connections • CAN link between rear SAM control unit and cockpit CAN-B voltage distributor (plug G) • CAN: Overhead control panel control unit (plug G) CAN signals The rear SAM control unit (N10/8) is a device on the CAN-B in the overall network. n00.19-P-0999GZ Model 164.1 except code (498) Japan version nCurrently not documented (model 251) i Note In vehicles with code 551 the towing sensor (ATA inclination sensor) for the ATA function is integrated in the rear SAM control unit (N10/8). In vehicles with trailer hitch with code 550 the trailer recognition control unit is integrated in the rear SAM control unit (N10/8). Wiring diagrams with pin/connector assignments Current information on the wiring diagram and on the connector assignments can be found in the documentation in WIS. Fuse and relay assignments Current information on the assignments can be found in the documentation in WIS. Voltage supply for the following control units • No voltage supply for control units 14 b Overview of SAM Control Units/Current Passenger Car Model Series 2005 – This printout will not be recorded by the update service. Status: 08 / 2005 – Model 164/251 Rear SAM control unit P54.21-2598-00 Connector assignment of rear SAM control unit (N10/8) Circuits and assignments Workshop Information System (WIS) Wiring diagrams and pin/connector assignments, control unit N10/8 r54.21-P-2103MAA Sheet 1 Model 164 r54.21-P-2103MAB Sheet 2 r54.21-P-2103RAA Sheet 1 Model 251 r54.21-P-2103RAB Sheet 2 Fuse and relay assignments Model 164.1/8 n54.15-P-0800GZ Model 251 n54.15-P-1269RT Overview of SAM Control Units/Current Passenger Car Model Series 2005 b – This printout will not be recorded by the update service. Status: 08 / 2005 – 15