REARSUGGESTED
ACCESS GRID
TROFFER
MOUNTING
FOR
INSTALLATION
GUIDE
REAR ACCESS
GRID TROFFER
G3 & G4 Series
1. Place luminaire in grid ceiling in desired orientation.
1. Place luminaire in grid ceiling in desired orientation.
2. Loosen rear access door by turning (4) 1/4 turn fasteners and raising lid for access.
2. Loosen rear access door by turning (4) 1/4 turn fasteners and raising lid for access. Attach handle (A) to rear access lid Attach handle (A) to rear access lid as shown and secure with (2) 10-24 palnuts provided.
as shown and secure with (2) 10-24 palnuts provided.
3.3.
Attach
door
retainer
bracket
(B)(B)
to rear
access
door
as shown
withwith
6-32
x 1/4”
screws
(2 provided).
Attach
door
retainer
bracket
to rear
access
door
as shown
6-32
x 1/4"
screws
(2 provided).
4. Raise door, swivel and lift prop rod (attach to luminaire), and place round projection of prop rod though hole in door 4. Raise door, swivel and lift prop rod (attached to luminaire), and place round projection of prop rod
retainer bracket. Door will now support itself.
through hole in door retainer bracket. Door will now support itself.
5. Now make all necessary wire connections to luminaire.
6.5.
Unhook
prop all
rod,
close andwire
secure
door.
Now make
necessary
connections
to luminaire.
6. Unhook prop rod, close and secure door.
A
B
Cleaning Instructions: Wipe luminaire with a soft cloth slightly dampened with warm, soapy water.
On stainless steel units, tightly adhering deposits may be removed by using a stainless steel polishing powder.
Never use steel wool or steel brushes on stainless steel. Always rub in the direction of the polish lines.
Note: All luminaires to be installed by a qualified electrician.
Mounting and electrical hardware not supplied by Paramount Industries unless otherwise noted.
PARAMOUNTINDUSTRIES, INC.
Paramount Industries, Inc.
800-521-5405
Fax 800-852-7154
www.paramountlighting.com
REVISED 06/2012